User manual SMEG GKOC64NLK

[. . . ] Contents 1 Instructions 1. 1 1. 2 1. 3 1. 4 1. 5 1. 6 1. 7 General safety instructions Manufacturer liability Appliance purpose Identification plate This user manual Disposal How to read the user manual 30 30 33 33 33 33 34 35 2 Description 2. 1 General Description 2. 2 Symbols 2. 3 Available accessories 36 36 36 37 3 Use 3. 1 Instructions 3. 2 First use 3. 3 Using the hob 38 38 38 39 4 Cleaning and maintenance 4. 1 Instructions 4. 2 Cleaning the appliance 41 41 41 5 Installation 5. 1 5. 2 5. 3 5. 4 5. 5 5. 6 Safety instructions Positioning in the counter top Mounting Gas connection Adaptation to different types of gas Electrical connection 43 43 43 47 48 51 54 These instructions apply only for the destination countries listed on the appliance’s data plate. This is a class 3 built in hob. We advise you to read this manual carefully, which contains all the instructions for maintaining the appliance’s aesthetic and functional qualities. For further information on the product: www. smeg. com 29 EN Instructions 1 Instructions 1. 1 General safety instructions Risk of personal injury • During use the appliance and its accessible parts become very hot. Never touch the heating elements during use. [. . . ] This pan support can also be used with woks. 2. 3 Available accessories Raised pan support To prevent damage to the worktop, a raised pan support is available to place under pans having a diameter greater than those indicated in the “Cookware diameters” table in section 3. 3 “Using the hob”. 37 EN Use 3 Use 3. 1 Instructions Improper use Danger of burns • Make sure that the flame-spreader crowns are correctly positioned in their housings with their respective burner caps. • Oils and fats could catch fire if overheated. • Do not leave the appliance unattended during cooking operations where fats or oils could be released. • Do not spray any spray products near the appliance. • Do not touch the appliance’s heating elements when it is in operation. • Keep children under the age of 8 away from the appliance when it is in use. Improper use Risk of damage to surfaces • Do not use aluminium foil to cover the burners or hob body. • Cookware should be placed inside the perimeter of the hob. • All pans must have smooth, flat bottoms. • If any liquid does boil over or spill, remove the excess from the hob. 3. 2 First use 1. Remove any protective film from the outside or inside of the appliance, including accessories. Remove any labels (apart from the technical data plate) from accessories. Remove and wash all the appliance accessories (see 4 Cleaning and maintenance). 38 Use 3. 3 Using the hob All the appliance’s control and monitoring devices are located together on the front panel. The appliance is equipped with an electronic ignition device. Simply press the knob and turn it anti-clockwise to the maximum flame symbol, until the burner ignites. If the burner does not light in the first 15 seconds, turn the knob to and wait 60 seconds before trying again. After lighting, keep the knob pressed in for a few seconds to allow the thermocouple to heat up. The burner may go out when the knob is released: In this case, the thermocouple has not heated up sufficiently. Wait a few moments and repeat the operation. In case of an accidental switching off, a safety device will be tripped, cutting off the gas supply, even if the gas cock is open. Return the knob to and wait at least 60 seconds before lighting it again. Positioning the pan stands The grids are supplied assembled on the hob. [. . . ] Following adjustment to a gas other than the one originally set in the factory, replace the gas setting label on the appliance with the one corresponding to the new gas. The label is inserted inside the nozzle pack (where present). Turn the adjustment screw on the side of the valve stem until a steady minimum flame is obtained. Over time the gas cocks may become difficult to turn and get blocked. [. . . ]