User manual SMEG GKOC75-3NLK

[. . . ] Contents 1 Instructions 1. 1 1. 2 1. 3 1. 4 1. 5 1. 6 1. 7 General safety instructions Manufacturer’s liability Appliance purpose Identification plate This user manual Disposal How to read the user manual 32 32 35 35 35 35 36 37 2 Description 2. 1 General Description 2. 2 Symbols 2. 3 Available accessories 38 38 38 39 3 Use 3. 1 Instructions 3. 2 First use 3. 3 Using the hob 40 40 40 41 4 Cleaning and maintenance 4. 1 Instructions 4. 2 Cleaning the appliance 43 43 43 5 Installation 5. 1 5. 2 5. 3 5. 4 5. 5 5. 6 5. 7 Safety instructions Positioning in the counter top Mounting Gas connection Adaptation to different types of gas Electrical connection Instructions for the installer 45 45 45 49 50 53 56 57 These instructions apply only for the destination countries listed on the appliance's data plate. This is a class 3 built in hob. We advise you to read this manual carefully, which contains all the instructions for maintaining the appliance’s aesthetic and functional qualities. For further information on the product: www. smeg. com 31 EN Instructions 1 Instructions 1. 1 General safety instructions Risk of personal injury • During use the appliance and its accessible parts become very hot. Never touch the heating elements during use. [. . . ] • Do not touch the appliance’s heating elements when it is in operation. • Keep children under the age of 8 away from the appliance when it is in use. Improper use Risk of damage to surfaces • Do not use aluminium foil to cover the burners or hob body. • Cookware should be placed inside the perimeter of the hob. • All pans must have smooth, flat bottoms. • If any liquid does boil over or spill, remove the excess from the hob. 3. 2 First use 1. Remove any protective film from the outside or inside of the appliance, including accessories. Remove any labels (apart from the technical data plate) from accessories. Remove and wash all the appliance accessories (see 4 Cleaning and maintenance). 40 Use 3. 3 Using the hob All the appliance’s control and monitoring devices are located together on the front panel. The appliance is equipped with an electronic ignition device. Simply press the knob and turn it anti-clockwise to the maximum flame symbol, until the burner ignites. If the burner does not light in the first 15 seconds, turn the knob to and wait 60 seconds before trying again. After lighting, keep the knob pressed in for a few seconds to allow the thermocouple to heat up. The burner may go out when the knob is released: In this case, the thermocouple has not heated up sufficiently. Wait a few moments and repeat the operation. In case of an accidental switching off, a safety device will be tripped, cutting off the gas supply, even if the gas cock is open. Return the knob to and wait at least 60 seconds before lighting it again. Positioning the pan support grids The pan support grids are provided unassembled on the hob. Food stains or residues Do not use steel sponges and sharp scrapers as they will damage the surface. Use normal, non-abrasive products and a wooden or plastic tool, if necessary. Rinse thoroughly and dry with a soft cloth or a microfibre cloth. Cooking hob pan support grids Remove the pan support grids and clean them in lukewarm water and non-abrasive detergent. [. . . ] • Do not pull the cable to remove the plug. • Use cables withstanding a temperature of at least 90°C. • The tightening torque of the screws of the terminal supply wires must be 1. 5 2 Nm. General information Check the grid characteristics against the data indicated on the plate. [. . . ]