User manual SMEG GS326-449

[. . . ] The route of the flue must be as short as possible. Do not connect the extractor hood to exhaust ducts carrying combustion fumes (boilers, fireplaces, etc. ). If the extractor is used in conjunction with non-electrical appliances (e. g. [. . . ] gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. USE The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. Never use the hood for purposes other than for which it has been designed. Never leave high naked flames under the hood when it is in operation. Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. Do not flamb under the range hood; risk of fire This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. MAINTENANCE Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. Clean and/or replace the Filters after the specified time period (Fire hazard). (fig. 5) Move the entire filter holder unit until it is properly aligned with the wall unit. (fig. 6) Keeping the hood canopy still, remove the sliding panel and lock the adjustment screws again. (fig. 5) The hood can now be fastened to the wall unit using the four screws 12a (3. 5 x 16) provided. (fig. 7) Replace the metal grease filters. Close the sliding suction panel again. 1 10 162 523 2 3 4 Vr 5 6 12a 7 EN 1 14 4 Connections DUCTING VERSION AIR EXHAUST SYSTEM When installing the hood in ducting version, a rigid or a flexible pipe with the diameter corresponding to the flange diameter is used in order to connect the hood to the air outlet piping. Fix the pipe with an adequate quantity of clamps (not supplied). pipe RECIRCULATION VERSION AIR OUTLET Cut a hole 125 mm in any shelf that may be positioned over the hood. Insert the flange 10a on the hood body outlet. Connect the flange to the outlet on the shelf over the hood using a flexible or rigid pipe 120 mm. [. . . ] Connect the flange to the outlet on the shelf over the hood using a flexible or rigid pipe 120 mm. Fix the pipe in position using sufficient pipe clamps (not supplied). Fix the directional grille 8 on the recirculation air outlet using the 2 screws 12e (2, 9 x 12, 7) provided. [. . . ]