User manual SMEG GW4090-60

[. . . ] Please keep this manual in a safe place and pass it on to new owners for their information and safety. Safety instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Connection and operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Concerning the hob . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] As long as the H lights up after the cooking zone has been switched off, the residual heat can be used for melting food or for keeping food warm. The cooking zone may still be hot when the letter H no longer lights up. The glass ceramic is not directly heated in the case of an induction cooking zone; it is only heated up by heat reflected by the pan. 19 Operation Switch on the cooking zone 1. Press the ON/OFF key short signal will sound. GB until "0" blinks in the power setting display. Then immediately press the plus key to select the power setting can be used to reduce the setting. The minus key power setting display shows the power setting which has been selected. A power level will be activated direct when one of the power setting pre/ / is pressed. select keys Key - Power level 7 Key - Power level 11 Key - Power level 15 The power setting display blinks (pan recognition). Immediately put cookware suitable for induction cooking onto the cooking zone. The pot or pan will be heated up. Suitable for induction cooking Note!· Should the cooking zone be switched on and no power setting be selected, the cooking zone will switch off automatically. Switching off a cooking zone 4. the ON/OFF key or Power management For technical reasons two cooking zones always comprise a module and have a maximum power level. If this power range is exceeded when a higher power setting level or the power boost function is switched on the power management system will reduce the power setting of the corresponding cooking zone of the module. This will be shown in the display of the respective cooking zone. Modules (power management) 21 Cleaning and Care Cleaning and Care GB Specific soiling Heavy soiling and stains (limescaling and shiny, mother-ofpearl-type stains) can best be removed when the hob is still slightly warm. Use commercial cleaning agents to clean the hob. First soak food which has boiled over with a wet cloth and then remove remaining soiling with a special glass scraper for glass ceramic hobs. Then clean the hob again as described under Item 2. · Before cleaning, switch off the hob and let it cool down. · Never clean the glass ceramic hob with a steam cleaner or similar appliance!· When cleaning make sure that you only wipe lightly over the ON/OFF key. The hob may otherwise be accidentally switched on! Glass ceramic hob Important!Never use aggressive cleaning agents such as rough scouring agents, abrasive saucepan cleaners, rust and stain removers etc. [. . . ] · Make sure that the local mains voltage is the same as the voltage on the rating label. · Full protection against accidental contact must be ensured on installation. Incorrect connection may result in the power electronics unit being destroyed. No mains cable present in the factory · To connect the appliance, unscrew the switchbox cover on the underside of the appliance to access the terminal block. [. . . ]