User manual SMEG GW4090-63

[. . . ] You can often fix minor problems yourself, without having to call in an engineer. Please keep this manual in a safe place and pass it on to new owners for their information and safety. Safety instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Connection and operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If no pot is placed on the cooking zone it will switch off after 10 minutes for reasons of safety. Please refer to the section on "Pan recognition" . Repeat items 2 to 4 in order to cook on other cooking zones at the same time. Cooking pots and pans will not need to have magnetic properties in the case of radiant heating elements (proceed according to items 2 and 3). Cooking zone selection buttons Stand-by dot Suitable for induction cooking Switching off a cooking zone 5. The stand-by dot of the cooking zone selected must light up. It may be necessary to press the cooking zone selection button. a) Press the minus button display shows 0, or several times until the power setting b) press the minus button and the plus button once at the same time. The cooking zone is switched off direct irrespective of the power setting or c) press the on/off button . The entire hob will be switched off (all of the cooking zones are switched off). Switching off the hob 7. The hob will be completely switched off, irrespective of any settings. 23 Operation STOP function GB The cooking process can be briefly interrupted with the STOP function, e. g. Timer indicator lamps can only blink if the cooking zones have already been switched on (power setting higher than 0). Then immediately use the minus button or the plus button to set the cooking time at between 1 and 99 minutes. With the plus button the display will commence at 01, and with the minus button it will commence at 30. The setting will be reset if the plus and minus buttons are pressed simultaneously (00). In order to program the automatic-switch-off device for another cooking zone, press the timer selection button repeatedly until the timer indicator lamp for the required cooking zone blinks. Then use the minus button or the plus button to set the required time. The cooking zone will be switched off when the time has lapsed. A signal will sound for a while and can be switched off by pressing any button (except for the on/off button). Timer indicator lamp Stand-by dot for the automatic switch-off device Minute minder lamp Please note · In order to check the time that has lapsed (automatic-switch-off device) press the timer selection button repeatedly until the timer indicator lamp for the required cooking zone blinks. The setting displayed can be read and changed. · Terminating the function of the timer: select the respective cooking zone (timer indicator lamp blinks) and press the plus and minus buttons once at the same time. Minute minder (egg timer) · Press the timer selection button until the minute minder lamp blinks with this button. Use the minus button or the plus button to set the time in minutes. [. . . ] The horizontal drive of the clips must be flush with the worktop (avoid the risk of breaks). · Position the hob according to the illustration on the left side (a), align it (b) and insert the clips (c). · Screws may be used to fasten the clips. There is a risk of breakage if the hob is canted or subjected to stress during installation! Minimum distance to adjacent walls Cut-out dimension Outer dimensions of the hob Cable routing in rear wall Installation height Bracket · Insert the hob and align it. [. . . ]