User manual SMEG IGE3958W1

[. . . ] For improved garment care, spin speed is restricted to 400 rpm in this programme. Programme Care Labels Detergents and Additives PreMain Softener wash Wash 5. 0 - for temperature selection, respect the manufacturer's recommendations on the care label Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen. For washing heavily soiled laundry, the "Prewash" option can be selected. Selecting "Cotton 95", this programme eleiminates bacteria, ensuring sanitization of your laundry. The bacteria removal efficiency has been tested following a similar methodology to the NF EN 13697 standard of Nov. [. . . ] Make sure there are no kinks in the hose. Check water-tightness of tap and washing machine connections by turning the tap completely on. If the hose is too short, replace it with a suitable hose available through our After-Sales Service or your specialist retailer. Periodically check the hose for brittleness and cracks. Replace it if necessary by a new hose available through our After-Sales Service or your specialist retailer. The washing machine can be connected without a non-return valve. A Water stop anti-flooding system (see inlet hose type as shown on the right - depending on model) · Screw the hose to the water supply tap. Turn the tap fully on and check the water-tightness of the connection. · The washing machine must not be connected to the mixing tap of a non-pressurized water heater!· The inlet hose and the plastic enclosure contain (depending on model) electrical components: do not cut the hose and do not immerse the enclosure in water. · If the flexible hose is damaged, unplug the washing machine from the mains immediately, turn off the tap and replace the hose. If the flexible hose is too short, replace it with a 3 m Water Stop hose (available from After-Sales Service or from your dealer). Connect the water drain hose 1. Fit the replacement 13 A fuse into the fuse cover. For all other types of plug, the supply socket should be protected by a 16 A fuse or circuit breaker at the distribution board. GB 5 BEFORE THE FIRST WASH CYCLE To remove any residual water used in testing by the manufacturer, we recommend that you carry out a short wash cycle without laundry. Add a small amount of detergent (maximum 1/3 of the quantity the detergent manufacturer recommends for lightly soiled laundry) to the main wash chamber of the detergent dispenser. Select and start programme "Synthetics" at 60°C (see separate the programme chart). PREPARATION OF THE LAUNDRY Sort the laundry 1. · Type of fabric / care label symbol Cottons, mixed fibres, easy care/synthetics, wool, handwash items. · Colour Separate whites and coloureds. · Size Wash items of different sizes in the same load to improve washing efficiency and distribution in the drum. · Fabric delicacy Wash delicate articles separately: use a special programme for Pure New Wool , curtains and other delicates. Always remove curtain glides or wash curtains with the glides inside a cotton bag. Use the special programme for handwash fabrics. Wash stockings, belts and other small items or articles with hooks (e. g. [. . . ] Push the "Reset" button for at least 3 seconds and wait until the "Door open" lights up. Open lid and close drum flaps, then select and start desired programme again. If fault persists, notify our After-Sales Service. "Electrical module fault" Select and start "Drain" programme or push "Reset" button for at least 3 seconds. [. . . ]