User manual SMEG IGE3964N

[. . . ] Yellow/orange illuminated button (if provided): activates/deactivates the fast freeze function. It lights up when the fast freeze function is active. The exact configuration of the controls may vary according to the model. Switching on the appliance · The appliance is factory set for optimum operation at a temperature of -18°C. [. . . ] If there is a long power failure: · Do not open the appliance lid except to place ice packs (if provided) over the frozen foods on the right and left of the appliance. This will slow down the rise in temperature. INSTRUCTIONS FOR USE PRECAUTIONS AND ADVICE · After installation, make sure the appliance is not resting on the power cable. · Do not store glass containers with liquids in the appliance, as they could burst. · Do not eat ice cubes or ice lollies immediately after taking them out of the appliance, since they could cause cold burns. · Before carrying out any maintenance or cleaning operation, unplug the appliance or disconnect the electrical power supply. · Do not install the appliance in places exposed to direct sunlight or near heat sources, as this will result in higher energy consumption. · Do not store or use petrol or other flammable liquids and gases in the vicinity of this or other electrical appliances. The fumes can create a fire hazard or explosion. · Install and level the appliance on a floor able to take its weight and in a place suitable for its size and use. · Install the appliance in a dry and well-ventilated place. The appliance is arranged for use in places with temperatures inside the following ranges defined according to the climatic class given on the dataplate located on the back. · In order to avoid permanent damage to the appliance interior, do not use pointed or sharp metal instruments for removing the ice. · Do not use abrasive products or heat up the interior artificially. · Dry the interior of the appliance thoroughly. · On completion of the defrosting, refit the plug. CARE AND MAINTENANCE · Remove the ice from the upper edge (see the Troubleshooting Guide). · Clean the inside after defrosting, using a sponge dampened with warm water and/or mild detergent. · Clean the side motor cooling grille (depending on model). · Remove dust from the condenser on the rear of the appliance. Before carrying out maintenance, unplug the appliance. Do not use abrasive products, scourers or stain-removers (e. g. acetone, trichloroethylene) to clean the appliance. [. . . ] · Has the fast freeze function (depending on model) been pressed by mistake?· Are the defrost water drainage plugs correctly positioned?· Is the appliance lid properly closed?· Is the appliance lid seal damaged or deformed? [. . . ]