User manual SMEG IGE3980

[. . . ] 2. 3) towards the opposite side and remove the filters. Remove the pull-out drawer completely and mount the grease filter so that it covers the drawer. Close the drawer and install the remaining grease filter. According to model in possession: Lamp D with hook locks type A - Fig. 2. 2 Move the bracket hook locks towards each other (in direction "Open" as printed on the plastic part of the lock). [. . . ] 1. 2 Move the hook locks as indicated by the arrows and completely remove the lamp from the housing (Fig. 1. 3). Installation When installed, the distance between the hood and burners must be not less than 43 cm for electric burners or 65 cm for gas or mixed-fuel burners. Caution This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance. Do not use the cooker hood where the grill is not correctly fixed!The suctioned air must not be conveyed in the same channel used for fumes discharged by appliances powered by other than electricity. The environment must always be adequately aerated when the cooker hood and other appliances powered by other than electricity are used at the same time. Flambé cooking with a cooker hood is prohibited. The use of a free flame is damaging to the filters and may cause fire accidents, therefore free flame cooking must be avoided. Frying of foods must be kept under close control in order to avoid overheated oil catching fire. Carry out fumes discharging in accordance with the regulations in force by local laws for safety and technical restrictions. The manufacturers refuse to accept any responsibility for damage to the hood or its catching on fire because of failure to observe the above instructions. Systems Available Venting Outdoors The air is vented outdoors through a duct which must be connected to the exhaust opening K (Fig. Remove the grease filters and open the light cover support (or the greas filter support grate). Reverse the procedure described in item 1) or 2), depending on the version, of the "Air recirculation" paragraph. Adjusting the Pull-Out Drawer The hood can be installed beneath cabinets with varying depths. Adjustments for opening and closing the drawer can be made based on your specific needs. To adjust the drawer, remove the ventilation grates by loosening the O screws and adjusting the P brackets. 10). Using the hood The hood is provided with several speeds. For the best performance, we recommend using the low speeds in normal conditions and the high speeds when strong odour and vapour concentrations are present. We recommend starting the hood a few minutes before cooking and keeping it running for at least 15 minutes until all the odours have been eliminated. Replacing the Lamp a. Open the light cover support or the back grease filter support grate. Always replace burnt-out lamps, according to what is provided for your appliance, with olive-shaped max. 40 Watt (E 14) bulbs, or neon-lamp 14 Watt max. , or PL lamp 11 Watt (one PL lamp appliance) or PL 9 Watt (two PL lamp appliance). Close the light cover support or the back grease filter support grate. [. . . ] 40 Watt (E 14) bulbs, or neon-lamp 14 Watt max. , or PL lamp 11 Watt (one PL lamp appliance) or PL 9 Watt (two PL lamp appliance). Close the light cover support or the back grease filter support grate. Before calling for customer service because the lighting system does not work, make sure that the lamps are screwed in tightly. Cleaning To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. [. . . ]