User manual SMEG IGE5665

[. . . ] · Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. · The hood should not be used by children or persons not instructed in its correct use. MAINTENANCE · Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. · Clean and/or replace the Filters after the specified time period. [. . . ] · Mark a reference point on the horizontal reference line as indicated, 116 mm from the vertical reference line. · Repeat this operation on the other side. · Drill ø 8 mm holes at all the centre points marked. · Insert the wall plugs 11 in the holes. · Fix the brackets using the 12a screws (4, 2 x 44, 4) supplied. · Insert the two screws 12a (4, 2 x 44, 4) supplied in the hood body fixing holes, leaving a gap of 56 mm between the wall and the head of the screw. GB 965 X 7. 2. 1 14 Mounting the hood body · Before attaching the hood body, tighten the two screws Vr located on the hood body mounting points. · Hook the hood body onto the screws 12a · Fully tighten support screws 12a · Adjust screws Vr to level the hood body. Vr 12a Connections DUCTED VERSION AIR EXHAUST SYSTEM In order to install the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 mm, the choice of which is left to the installer. · Push fit Damper 10 onto the air outlet. · Fix the pipe in position using sufficient pipe clamps (not supplied). · Remove any activated charcoal filters. ø 150 10 RECIRCULATION VERSION AIR OUTLET · Push fit connection 15 onto the air outlet. · Insert the connection extension pieces laterally 14. 1 in connection 15. · Remove the grease filters from the hood. · If the hood is of the recirculation type, remove the odour filters. · Remove the halogen-lamps support by taking off the two fixing screws. · Disconnect the power connector Ca and the control and lighting connector Cmd on the sides of the unit. · Turn the levers Lb locking the suction unit, so that they disconnect from the pins. · Pull the suction unit forwards so that it unhooks from the support pins, and remove it downwards through the air outlet. Ca Cmd Lb GB 18 Activated charcoal filter (Recirculation version) REPLACING THE ACTIVATED CHARCOAL FILTER · The filter is not washable and cannot be regenerated. It must be replaced when led S1 flashes twice or at least every 4 months. The alarm signal will only light up when the extractor motor is switched on. Alarm signal reset · Switch off the lights and extractor motor. · Press button V2 for at least 3 seconds, until the leds start to flash. Replacing the Filter · Remove the metal grease filters · Remove the saturated activated carbon filter by releasing the fixing hooks · Fit the new filter by hooking it into its seating · Replace the metal grease filters. [. . . ] · Replace the Support, fixing it in place with the two Screws removed as above. GB 19 Quest'apparecchio è conforme alla norma europea sulla bassa tensione C. E. E. 73/23 relativa alla sicurezza elettrica e alle norme europee: C. E. E. 89/336 relativa alla compatibilità elettromagnetica e C. E. E. This appliance conforms to European Low Voltage Directive 73/23/CEE governing electrical safety, European Directive 89/336/CEE on Electromagnetic Compatibility and Directive 93/68/CEE regarding CE Marking. [. . . ]