User manual SMEG KDD90VXE

[. . . ] The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. When the cooker hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the room must not exceed 0, 04 mbar to prevent fumes being drawn back into the room by the cooker hood. • In the event of damage to the power cable, it must be replaced by the manufacturer or by the technical service department, in order to prevent any risks. • If the instructions for installation for the gas hob specify a greater distance specified above, this has to be taken into account. [. . . ] • To install a ø 120 mm air exhaust connection, insert the reducer flange 9 on the hood body outlet. • Fix the pipe in position using sufficient pipe clamps (not supplied). • Remove possible charcoal filters. ø 150 9 ø 120 AIR OUTLET – RECIRCULATION VERSION • Connect the Flange to the air outlet opening using a rigid or flexible pipe of ø120 or 150 mm. • To connect using a ø120 mm pipe, insert the reduction Flange 9 onto the Hood canopy outlet. • Fasten the pipe using suitable pipe clamps. The materials required to do so are not provided. • Fix the directional Grid 8 on the outlet, using 2 screws 12e (2. 9 x 9. 5) provided. • Make sure that the activated charcoal filters are present (see paragraph on Activated Charcoal Filter Maintenance). ELECTRICAL CONNECTION • Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. . APPLIANCE IN LET EN 3 30 Fitting the Front element • Lift the mobile hood canopy (see paragraph on Use) by just a few centimetres. • To stop movement, simply press down on the mobile canopy as it lifts up. Warning: Never block the sliding door when it is opening or closing, except during the operations required to fit the frame. • Remove the sponge guards from the corners of the glass. • Take the front Frame and insert it from above, making sure that its tabs insert into the slots provided on the Hood and sliding it to the left. Warning. . : All the tabs must be inserted. Warning. . : Handle with care • Use a tool (hammer) to tap all along the front Frame from right to left until it is completely flush. A piece of wood or similar element can be inserted between the hammer and the front Frame to prevent any damage. • Please refer to the paragraph on Use for indications of how to return the mobile canopy to the Standard position. EN 3 31 Surround Suction Panel • Open the Hood Door (see USE). • Remove the 2 strips of adhesive tape fastening the panel during transport. EN 3 32 USE Control panel But ton A Function The button only works when the door is open. Press and hold the button for approximately 5 seconds, with all the loads turned off (Motor and Lights), to turn the Remote control On/Off. Press Briefly = Turns the Lights On/Off at maximum intensity. Press and hold for 2 Seconds = Turns the Courtesy Lights On/Off. The button only works when the door is open. Activates / Deactivates the 24h function which turns the motor on at speed one for 10 minutes every hour, for 24 hours. At the end of this time the hood turns Off. [. . . ] • Press and hold button G for 2 seconds. Changing the Filter • Remove the comfort panel. • Remove the metal filter stops from the grease filter and clean the saturated activated charcoal odour filter. • Replace the clean activated charcoal filter, hooking it back up to the grease filter using the metal filter stops. [. . . ]