User manual SMEG KDD90VXE-2

[. . . ] The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. When the cooker hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the room must not exceed 0, 04 mbar to prevent fumes being drawn back into the room by the cooker hood. • In the event of damage to the power cable, it must be replaced by the manufacturer or by the technical service department, in order to prevent any risks. EN 2 22 • The manufacturer will not be held liable for any damages resulting from • If the instructions for installation for the gas hob specify a greater distance specified above, this has to be taken into account. [. . . ] • The position indicated in the figure is only an option, as if necessary it may also be fitted on the left of the Hood Canopy or even left free on the base of the unit if there are no structural or safety problems involved. Warning. . : Do not install the product in such a way that the wiring box is in contact with the floor. EN 3 33 Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. • To install a ø 120 mm air exhaust connection, insert the reducer flange 9 on the hood body outlet. • Fix the pipe in position using sufficient pipe clamps (not supplied). • Remove possible charcoal filters. ø 150 9 ø 120 AIR OUTLET – RECIRCULATION VERSION • Connect the Flange to the air outlet opening using a rigid or flexible pipe of ø120 or 150 mm. • To connect using a ø120 mm pipe, insert the reduction Flange 9 onto the Hood canopy outlet. • Fasten the pipe using suitable pipe clamps. The materials required to do so are not provided. • Fix the directional Grid 8 on the outlet, using 2 screws 12e (2. 9 x 9. 5) provided. • Make sure that the activated charcoal filters are present (see paragraph on Activated Charcoal Filter Maintenance). ELECTRICAL CONNECTION • Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. . APPLIANCE INLET EN 3 34 Fitting the Front element • Lift the mobile hood canopy (see paragraph on Use) by just a few centimetres. • To stop movement, simply press down on the mobile canopy as it lifts up. Warning: Never block the sliding door when it is opening or closing, except during the operations required to fit the frame. • Remove the sponge guards from the corners of the glass. • Take the front Frame and insert it from above, making sure that its tabs insert into the slots provided on the Hood and sliding it to the left. Warning. . : All the tabs must be inserted. • Use a tool (hammer) to tap all along the front Frame from right to left until it is completely flush. A piece of wood or similar element can be inserted between the hammer and the front Frame to prevent any damage. • Please refer to the paragraph on Use for indications of how to return the mobile canopy to the Standard position. Warning. . : Handle with care EN 3 35 Surround Suction Panel • Open the Hood Door (see USE). • Remove the 2 strips of adhesive tape fastening the panel during transport. EN 3 36 USE Control panel But ton A Function The button only works when the door is open. The alarm is triggered after the Hood has been in operation for 200 working hours. H Door Closed Opens the door and Motor + Lights = On. [. . . ] • Press and hold button G for 2 seconds. Changing the Filter • Remove the comfort panel. • Remove the metal filter stops from the grease filter and clean the saturated activated charcoal odour filter. • Replace the clean activated charcoal filter, hooking it back up to the grease filter using the metal filter stops. [. . . ]