User manual SMEG KE260NE

[. . . ] 1) Use the paper template provided to mark the hole positions on the underside of the cabinet. Pilot drill the fixing holes and fit the four 44, 4 mm fixing screws from the inside of the cabinet carcase. 2) Use the paper template provided to mark the hole positions on the wall for the bracket fixing screws. [. . . ] To remove the grille, release the right hand hinge pin from the slot along the casing and the grille can be removed (fig. Operation The cookerhood funtions are controlled by three slide switches (fig. 8) which are located in the centre of the grille panel behind the facia panel. The three slide switches control the fan (2), fan speed (3) and worktop illumination (1). A neon lamp (5) (optional) indicates when the cooker hood is working. A concealed microswitch (4) (optional) acts as an over-ride and will switch the hood off, whatever selection is made with the slide switches, when the facia panel is closed. When the panel is pulled open the hood will resume working at the previous setting. The first setting should be selected when simmering or when cooking with only one pan. The second setting should be selected for normal cooking up to four pans and the third setting should be selected when frying or cooking food with strong odours. In cases where the cookerhood is equipped with an electronic speed control switch, greater flexibility is available in selecting the most suitable fan setting. The hood should be switched on immediately when you start cooking and should be left running for approximately 15 minutes after finishing. 2 GB Maintenance Regular maintenance and cleaning will ensure good performance and reliability, while extending the working life of the hood. Special attention should be taken to keep the grease filter clean at all times and the charcoal filter (recirculation model) should be replaced regularly. To remove filters for subsequent cleaning and replacement first open the metal grille panel. Grease filter This retain the solid grease particles. [. . . ] For safety, when installed the hood must be positioned at least 65 cm above a cooking appliance. Never leave frying pans unattended during use as overheated fats and oils may catch fire. The cookerhood ducting must never be connected to central heating flues, radiators or water heaters, etc. [. . . ]