User manual SMEG KE455X

[. . . ] INSTRUCTIONS FOR SAFE AND PROPER USE______________ 113 INSTALLATION ________________________________________ 115 DESCRIPTION OF CONTROLS ___________________________ 118 USE OF THE OVEN _____________________________________ 128 AVAILABLE ACCESSORIES ______________________________ 129 COOKING HINTS _______________________________________ 130 CLEANING AND MAINTENANCE __________________________ 135 EXTRAORDINARY MAINTENANCE ________________________ 137 INSTRUCTIONS FOR THE INSTALLER: these are intended for the qualified technician who must install the appliance, set it functioning and carry out an inspection test. INSTRUCTIONS FOR THE USER: these contain user advice, description of the commands and the correct procedures for cleaning and maintenance of the appliance. 112 Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE OVEN. WE ADVISE CAREFUL READING OF THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE OVEN. [. . . ] It can be manually turned off by pressing key . 3. 2. 7 Minute-counter The programmer can also be used as a simple minute counter. The use of the minute-counter will not interrupt oven operation at the end of the set time. 122 Instructions for the user By pressing key , the display shows ; keep the key pressed and at the same time press keys or . By releasing the key , the programmed count starts and the symbols and appear on the monitor. After programming the minute-counter, the display will show the right time. Wrong settings are prevented logically (e. g. , any conflict between end of cooking time and a longer time will not be accepted by the programmer). 3. 2. 8 Cancellation of set data Once the programme has been set, keep the key of the function to be cancelled pressed, while at the same time is reached by means of or . Time cancellation will be considered as end-ofvariation keys cooking time by the programmer. 3. 2. 9 Changing the set data The cooking data entered can be changed at any time by keeping the function key pressed and at the same time adjusting the keys or . 123 Instructions for the user 3. 3 Electronic Analogue Clock (on some models only) LIST OF FUNCTIONS MINUTE-MINDER BUTTON AUTOMATIC SWITCH-OFF TIMING BUTTON TIME SETTING AND RESET VALUE DECREASE BUTTON VALUE INCREASE BUTTON 3. 3. 1 Setting the time When the oven is used for the first time, or after a power blackout, the display flashes on and off at regular intervals. Press the key for 1/2 seconds to stop the display flashing and start setting of the current time. Press the value modification keys or to increase or decrease by one minute for each time a key is pressed. Press one of the two value modification keys until the current time appears. The clock will start from the time set 6/7 seconds after the last key is pressed. At the end of each programmed cooking operation, the clock gives 8 beeps, repeated 3/4 times at intervals of about 1 and a half minutes. The beeps can be stopped at any moment by pressing any key. 3. 3. 2 Minute-minder This function does not stop cooking but just triggers the beeps. 124 Instructions for the user When the key is pressed the display illuminates, appearing as shown in figure 1; Press the or keys within 6/7 seconds to set the minute-minder. Whenever a key is pressed, 1 outside segment, representing 1 cooking minute 1 will light up (figure 2 shows 10 cooking minutes). The countdown will start 6/7 seconds after the last key is pressed; at the end of it, you will hear the beeps. Use the and keys to set the cooking start time. - 6/7 seconds after the last time a key is pressed, the display will show the current time and the cooking start and end times, indicated by the illuminated inside segments. The segments on the display will be constantly on until the current time is the same as the cooking start time; as soon as the current time reaches the cooking start time set, all the inside segments will start to flash, indicating that the oven has started cooking. - When the end of the cooking time is reached, the timer will switch off the oven heating elements, the beeps will start and the numbers on the dial will flash. - To reset the entire program set, keep the central key pressed for 1 or 2 seconds: if cooking has already started the oven will have to be switched off by hand. [. . . ] Take out all removable parts. 135 Instructions for the user · · · Clean the oven grill and side guides with hot water and non-abrasive detergent. The oven should be operated at the maximum temperature for about 15/20 minutes after using specific products, to eliminate the residues deposited inside the oven. For easier cleaning, the door can be removed (see P. 8. 2) 7. 3 Self-cleaning liners (only on some models) The oven is equipped with continuous self-cleaning enamelled liners. [. . . ]