User manual SMEG KEX705

[. . . ] · Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. · The hood should not be used by children or persons not instructed in its correct use. MAINTENANCE · Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. · Clean and/or replace the Filters after the specified time period. [. . . ] · Place bracket 7. 2. 1 on the wall as shown at X mm below the first bracket (X = height of the upper chimney section supplied), aligning the centre (notch) with the vertical line. · Mark the wall at the centres of the holes in the bracket. · Mark a reference point as indicated at 116 mm from the vertical reference line and 328 mm above the horizontal reference line. · Repeat this operation on the other side. · Drill ø 8 mm holes at all the centre points marked. · Insert the wall plugs 11 in the holes. · Fix the brackets using the 12a (4, 2 x 44, 4) screws supplied. · Insert the two screws 12a (4, 2 x 44, 4) supplied in the hood body fixing holes, leaving a gap of 56 mm between the wall and the head of the screw. GB X 7. 2. 1 14 Mounting the hood body · Before attaching the hood body, tighten the two screws Vr located on the hood body mounting points. · Hook the hood body onto the screws 12a · Fully tighten support screws 12a · Adjust screws Vr to level the hood body Vr 12a Connections DUCTED VERSION AIR EXHAUST SYSTEM In order to install the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 mm, the choice of which is left to the installer. · Push fit Damper 10 onto the air outlet. · Fix the pipe in position using sufficient pipe clamps (not supplied). · Wash the filters, taking care not to bend them. · When refitting the filters, make sure that the handle is visible on the outside. GB 18 Activated charcoal filter (Recirculation version) REPLACING THE ACTIVATED CHARCOAL FILTER · The filter is not washable and cannot be regenerated. It must be replaced when led S1 flashes twice or at least every 4 months. The alarm signal will only light up when the extractor motor is switched on. Alarm signal reset · Switch off the lights and extractor motor. · Press button V2 for at least 3 seconds, until the leds start to flash. Replacing the Filter · Remove the metal grease filters. · Remove the saturated activated carbon filter by releasing the fixing hooks. · Fit the new filter by hooking it into its seating Replace the metal grease filters. Alarm signal activation · On the recirulcation version extractor hood, the filter saturation alarm is activated during installation or at a later date. · Switch off the lights and extractor motor. [. . . ] · Replace the Support, fixing it in place with the two Screws removed as above. GB 19 Quest'apparecchio è conforme alla norma europea sulla bassa tensione C. E. E. 73/23 relativa alla sicurezza elettrica e alle norme europee: C. E. E. 89/336 relativa alla compatibilità elettromagnetica e C. E. E. This appliance conforms to European Low Voltage Directive 73/23/CEE governing electrical safety, European Directive 89/336/CEE on Electromagnetic Compatibility and Directive 93/68/CEE regarding CE Marking. [. . . ]