User manual SMEG KFBR30I

[. . . ] Do not plug the power supply with wet hands. Never touch the machine with wet hands or feet. Never open the detergent drawer while the device is running. Never force to open the door of the machine while the machine is running. [. . . ] Changing the program If you have selected a program and you do not want if to continue: Press the start/pause button. Bring the program knob to O(off) status. Adjust the program knob to the program you desire. (You can select the program that you desire from Table-1). By pressing the start/pause button, run the program which you have selected. Cancellation of the Program If you desire to end a running program early: Press the start/pause button. Turn the program knob to "Draining" or "Spinning" programs. Run the program you have selected by pressing the start/pause button. Program ending Your machine will automatically stop when the program you have selected ends. Turn the program knob to O(off) position. TYPE OF LAUNDRY Sport clothes All spore clothes and jeans Nylon socks, blouse Tulle, curtain, diolen, dralon EXPLANATIONS MAX DRY LOAD CAPACITY (kg) SWM834E 2 2 1 1 Silk mixture, shirt, blouse, polyester, poliamid, mixture textile SWM840E 3 3 2 2 2 2 3 3 KFBR30I 13-SPORT CLOTHES 2 2 1+2 2 14-SYNTHETIC COLD 15-CURTAIN WASH 16-DELICATE 30 17-DELICATE COLD 2 1 2 2 45 2 2 2 1 2 2 1 2 2 1 2 2 Very slightly dirty, cold water, hand and machine to wash wool laundry 18-HAND WASH Hand wash to all laundry 19-WOOL 30 Slightly dirty, synthetic or synthetic mixture sensitive laundry. Washed without heating the tap water. Tulle and curtain as sensitive laundry Slightly dirty, cotton, coloured, synthetic or synthetic mixture sensitive laundry Very slightly dirty, cold water with to wash cotton, coloured, synthetic or synthetic mixture sensitive laundry Slightly dirty, wash in hand cotton, coloured, synthetic or synthetic mixture laundry Dirty, hand and machine to wash wool laundry All wool laundry 20-WOOL COLD RINSING SPINNING DRAINING When you need an additional rinsing to be done to your clothes after the washing process, you can use this program for all kinds of clothes. Remove the siphon plug and clean the residues of the softener thoroughly. Fit the cleaned siphon plug in its location. Siphon plug THE CABINET Clean the exterior surface of the cabinet of your machine with lukewarm water and a cleaning substance that will not irritate the cabinet. After rinsing with clean water, wipe it with a soft and dry cloth. WARNING! If the machine is installed in a location where the ambient temperature can fall below 0 C, do the following when it will not be in use: Plug in the machine. Close the water tap and pull out the water inlet hose or hoses from the tap. Place the ends of the water drain and water inlet hoses in a cup on the ground. Adjust the program knob to "Draining" program. Run the program by pressing the start/pause button. Unplug your machine when the program is over (program end light is on). When you complete these proces, the remaining water inside the machine will be drained and thus formation of ice in the machine will be prevented. When you operate your machine again, be sure that the ambient temperature is above 0 C. [. . . ] Press the start/pause button. In order to stop the foam, dilute one table-spoon of softener in half liter of water and pour it in the detergent drawer. Press the start/pause button after 5-10 minutes. Arrange the amount of the detergent properly in the next washing process. Use only the detergents produced for full automatic machines. (see Table-1) Use more detergent according to the detergent. Wrong detergent has been used. The washing result is bad. Your laundry too dirty for the program you have selected. The amount of detergent used is not sufficient. 52 FAILURE PROBABLE CAUSE Clothes exceeding the maximum capacity has been filled in your machine. The washing result is not good. Your water may be hard. [. . . ]