User manual SMEG KI1207X

[. . . ] DE UK FR NL ES PT IT SE Montage- und Gebrauchsanweisung Instruction on mounting and use Prescriptions de montage et mode d'emploi Montagevoorschriften en gebruiksaanwijzingen Montaje y modo de empleo Instruções para montagem e utilização Istruzioni di montaggio e d'uso Monterings- och bruksanvisningar UK - Instruction on mounting and use Consult the designs in the front pages referenced in the text by alphabet letters. Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. Note: the elements marked with the symbol "(*)" are optional accessories supplied only with some models or elements to purchase, not supplied. [. . . ] The side of the trellis with the connection box corresponds to the side of the control panel once the hood is mounted. Fix the hood to the trellis with two screws that will also serve to centre the two parts. Screw the 4 screws that fix the trellis to the hood up with decision. Apply the nuts supplied with fixing hooks inside the sections of the upper and lower flues in correspondence with the rectangular slots. Couple the two upper sections of the hood to cover the trellis so that the slits on the sections are positioned, one on the same side as the command panel and the other on the opposite side. Screw the two sections up with 8 screws (4 per side ­ also see the diagram plan for the coupling of the two sections). Fix the entire upper flue to the trellis near the ceiling with two screws (one per side). Connect the electricity of the command panel and the bulbs. Couple the two lower sections of the hood to cover the trellis, using 6 screws (3 per side; also see the diagram plan for the coupling of the two sections). Insert the lower section into the apposite housing to completely cover the motor space and the electricity connections box. Apply 2 ribbons (supplied as kit) to cover the fixing points of the lower sections of the hood. THE RIBBONS FOR THE LOWER HOOD ARE RECOGNISABLE BECAUSE THEY ARE NARROWER AND LESS DEEP). The wider and deeper ribbons are those used for the upper hood and are to be cut to measure. Mount the carbon filter and the fat(s) filter/s) frame again and switch the electric supply on using the central electric panel and check the correct functioning of the hood. Using a pencil, draw a line on the wall, extending up to the ceiling, to mark the centre. Rest the drilling template against the wall: the vertical centre line printed on the drilling template must correspond to the centre line drawn on the wall, and the bottom edge of the drilling template must correspond to the bottom edge of the hood. Place the lower support bracket on the perforation diagram making it coincide with the traced triangle, mark the two external holes and perforate. Remove the perforation diagram, insert two wall-dowels and fix the support bracket of the hood with two 5x45 mm screws. Adjust the distance of the hood from the wall. Adjust the horizontal position of the hood. 7 Using a pencil mark the cooker hood permanent drill hole inside the suction group. Drill at the point marked (Ø8mm). Apply the flues support bracket G to the wall adherent to the ceiling, use the flues support bracket as a perforation diagram (if present, the small slot on the support must coincide with the line drawn previously on the wall) and mark two holes with a pencil. [. . . ] Prior to touching the light bulbs ensure they are cooled down. Extract the guard by levering it off with a small screwdriver or similar tool. Only use halogen bulbs of 12V -20W max - G4, making sure you do not touch them with your hands. Close the lamp cover (it will snap shut). [. . . ]