User manual SMEG KI120X

[. . . ] The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. USE The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. Never use the hood for purposes other than for which it has been designed. Never leave high naked flames under the hood when it is in operation. Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. [. . . ] Adjust the frame to the height required, then refit all the screws removed as above. Insert the upper chimney stack from above, and leave it running free on the frame. Lift up the frame, fit the frame slots onto the screws up to the slot end positions. Tighten the two screws and fasten the other two screws provided with the hood. Before tightening the screws completely it is possible to adjust the frame by turning it. Recirculation version Make sure that the outlet of the extension pieces 14. 1 is horizontally and vertically aligned with the chimney outlets. Otherwise, remove the lower chimney and adjust the position by inverting the extension pieces for air outlet connection 14. 1 or by cutting the hood body extension piece 14 (if any) along one of the chases destined to the predetermined extension lengths. Replace then the elements as earlier described. Fit the directional grids 8a - 8b in their housings making sure that the directional symbols are towards the top. Also make sure that they are correctly inserted in the connection extension pieces 14. 1. Before fixing the hood canopy to the frame: Screw the 2 screws 12f half way into the holes provided in the sides of the bottom of the frame. Remove the grease filters from the hood canopy. Lift the hood canopy and engage the screws 12f in the slots (A) as far as they will go. Working from below, fix the hood canopy to the frame (B), using the 4 screws 12q and 4 washers 22 provided, then tighten all the screws securely. 12c 12c 8b 8a 12f 12q 22 B A EN 1 19 9 ELECTRICAL CONNECTION Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. Remove the grease filters (see paragraph Maintenance) being sure that the connector of the feeding cable is correctly inserted in the socket placed on the side of the fan. Place the connectors in the junction box 24 and close it using the 2 screws 12e (2, 9 x 9, 5) provided. Fix the junction box to the hood body using the 2 screws 12c (2, 9 x 6, 5) provided. For the recirculation version, fit the activated carbon odour filter. Replace the grease filters. 24 12e Lux 12c Cmd EN 2 20 0 USE L1 L2 L3 L4 L T1 T2 Control panel T3 T4 Button L Function Led Press briefly to turn the lighting system on and off. 2 seconds to turn the lighting system on and off at reduced intensity. [. . . ] Leds (L1-L2-L3) flash once Activated Charcoal Filter saturation alarm DEACTIVATED. CHANGING THE ACTIVATED CHARCOAL FILTER Resetting the alarm signal Press any of the buttons except the Light button. Changing the Filter Remove the Metal grease filters. Remove the saturated Activated Charcoal filter, as shown in the figure. [. . . ]