User manual SMEG KI90C

[. . . ] Note: the elements marked with the symbol "(*)" are optional accessories supplied only with some models or elements to purchase, not supplied. will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. Caution WARNING!Do not connect the appliance to the mains until the installation is fully complete. [. . . ] Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the product. Use The hood is designed to be used either for exhausting or filter version. Ducting version The hood is equipped with a top air outlet B for discharge of fumes to the outside (exhaust pipe and pipe fixing clamps not provided). 1 Connect the hood and discharge holes on the walls with a diameter equivalent to the air outlet (connection flange). Using the tubes and discharge holes on walls with smaller dimensions will cause a diminution of the suction performance and a drastic increase in noise. Any responsibility in the matter is therefore declined. Filtering version In the case where it is not possible to discharge the cooking fumes and steam outside, the hood can be used in the filtering version, mounting 1 or 2 active carbon filters (*). The fumes and steam are recycled into the kitchen. 2 The models with no suction motor only operate in ducting mode, and must be connected to an external suction device (not supplied). 11 Installation Fig. 3-4-5-6-7-8-9-10-11-12 The minimum distance between the supporting surface for the cooking vessels on the hob and the lowest part of the range hood must be not less than 60cm from electric cookers and 70cm from gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. Maintenance ATTENTION!Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. Cleaning Electrical connection The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area. [. . . ] In any case it is necessary to replace the cartridge at least every four mounths. The carbon filter may NOT be washed or regenerated. Replacing lamps Fig. 16 Disconnect the hood from the electricity. [. . . ]