User manual SMEG KIR37XE

[. . . ] The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. When the cooker hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the room must not exceed 0, 04 mbar to prevent fumes being drawn back into the room by the cooker hood. • In the event of damage to the power cable, it must be replaced by the manufacturer or by the technical service department, in order to prevent any risks. EN 1 17 • The manufacturer will not be held liable for any damages resulting from • If the instructions for installation for the gas hob specify a greater distance specified above, this has to be taken into account. [. . . ] • For wooden shelf, drill ø 7 mm. • For the power supply cable feed, drill ø 10 mm. • For the air outlet (Ducted Version), drill according to the diameter of the external air exhaust duct connection. • Insert two screws of the following type, crossing them and leaving 4-5 mm from the ceiling: • For concrete ceilings, use the appropriate plugs for the screw size (not provided). • for Cavity ceiling with inner space, with wall thickness of approx. • For wooden beam ceilings, use 4 wood screws (not provided). • For wooden shelf, use 4 screws 12g with washers 22 and nuts 23, provided. EN 2 22 PREPARATION OF THE FRAME FOR THE HOOD IN RECYCLING VERSION In case the hood is used in recycling version it is necessary to prepare the frame with all the necessary connection pieces. In order to make the installation easier it is necessary to lengthen the frame: • Unscrew the two screws 2. 1 fixing the upper chimney to the frame and pull the chimney out. • Unscrew the four safety screws placed at the top in the frame separation area. • Unscrew the eight metric screws connecting the two columns, placed on both sides of the frame (B). Installation of components in recycling version: • Fix the recycling air outlet piece 15 to the upper part of the frame using four 12c screws supplied with the hood. • Fix the flange (ø120) 10 to the lower part of the recycling air outlet 15. • Put the reducer flange 9 on the hood body outlet. • At this point, join the flanges with a pipe. In order to calculate the height of the pipe it is necessary to estimate the height of the hood (mm) and subtract 615 mm. • Lengthen the frame so that the pipe can be inserted. Place the pipe between the two flanges and block it. Make sure that the height of the frame is correct considering the height of the cooker hood (H frame = H hood – 184). Adjust the height of the frame and tighten again the earlier removed screws. Tighten again the safety screws in order to give more stability to the structure. • Fix the pipe with the pipe clamps 25 supplied with the hood. A B 12c 15 10 EN 2 23 FIXING THE FRAME • Lift the frame up, making sure that the index over the frame plate is turned forwards. • Fit the frame slots onto the two screws inserted in the ceiling as above, and turn until reaching the centre of the adjustment slot. [. . . ] T2 Turn the suction motor on at speed two. Press and hold for approximately 5 seconds, with all the 2 flashes, Remote control Enabled. loads turned off (Motor and Lights), to enable/disable 1 flash, Remote control Disabled. T3 Turn the suction motor on at speed three. [. . . ]