User manual SMEG KIT1A1SE6 ISTRUZIONI VARIE

[. . . ] On completion of these operations, replace the “regulated for gas” label on the rear of the barbecue with the one supplied in the kit. The installation work must be carried out by a skilled technician. WARNING: Keep all the nozzles factory-fitted on the appliance, the union supplied and the “regulated for gas” label. It might be necessary to convert the appliance back from NATURAL GAS to LPG in the future. [. . . ] "REGULATED FOR" LABEL (TO BE APPLIED AFTER CONVERSION). 9 Instructions for the Installer CONNECTION TO THE MAINS GAS SUPPLY Connect the appliance to the mains natural gas supply using a rubber or steel hose in accordance with the relevant regulations. Screw the 5/8”-1/2” union (B) supplied onto the barbecue's gas inlet (C). Screw the union (A) onto the union (B) fitting the seal (D) between them, as shown. Fit the hose (F) onto the union (A) and secure it with a band clamp (E). A B C F E D Check that all the conditions listed below are met: • the hose must be fixed to the hose connector with a safety band clamp; • the hose must be accessible for inspection along its entire length (max. • the hose must not touch hot surfaces at any point (max. • there must not be any traction forces or stresses acting on the hose or any tight bends or kinks in it. • the hose must not touch sharp components or edges. • if the hose is not perfectly gastight and causes gas leaks, do not attempt to repair it ; replace it with a new hose. • check that the hose's expiration date has not been passed. If the appliance has been mounted on the optional trolley, lock the wheels using the clamps provided. 3 Replace the nozzle as specified in the table above. 4 Put the burner, the burner cap and the flame diffuser ring back into place correctly. 5 Fit the rear part back into place and screw on with the fixing screws. 1 2 12 Instructions for the Installer ADJUSTING THE PRIMARY AIR FLOWS The operations below must be carried out for every burner in the barbecue section: ADJUSTING THE PRIMARY AIR FLOW FOR "U"SHAPED BURNERS 1 Undo the adjuster screw A of the air regulator sleeve. 2 Turn the regulator sleeve B into the position for the type of gas to be used, consulting the table below. 3 Tighten the regulator screw, making sure that the distance X is correct (see table below). ADJUSTING THE PRIMARY AIR FLOW FOR "PARALLEL FLAME" BURNERS 1 Undo the adjuster screw A of the air regulator sleeve. 2 Pull the regulator sleeve B out or push it in to achieve the position for the type of gas to be used, consulting the table below. 3 Tighten the regulator screw, making sure that the distance X is correct (see table below). A X B A B X NATURAL GAS (N) U-shaped burners X= 4 mm G30/G31 (LPG) U-shaped burners 8 mm NATURAL GAS (N) Parallel flame burners 2 mm G30/G31 (LPG) Parallel flame burners 8 mm 13 Instructions for the Installer ADJUSTING THE BURNER MINIMUM SETTING CONVERTING FROM LPG TO NATURAL GAS Perform the operations described below on all the gas taps. Make sure that the by-pass inside is screwed fully down. Use a screwdriver inside or on the side of the rod (see right). [. . . ] Turn the bypass as stated in the BURNER CHARACTERISTICS, NOZZLES AND GAS CONSUMPTION table (see page 10). When adjustments are complete, fit the knob, light the relative burner and turn it to the minimum setting . The flame should be even at the minimum setting. Check that the flame remains stable when the knob is turned quickly from the maximum to the minimum setting. [. . . ]