User manual SMEG KIV90X

[. . . ] The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. USE · The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. · Never use the hood for purposes other than for which it has been designed. · Never leave high naked flames under the hood when it is in operation. · Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. [. . . ] · Adjust the frame to the height required, then refit all the screws removed as above. · Insert the upper chimney stack from above, and leave it running free on the frame. · Lift up the frame, fit the frame slots onto the screws up to the slot end positions. · Tighten the two screws and fasten the other two screws provided with the hood. Before tightening the screws completely it is possible to adjust the frame by turning it. Make sure that the screws do not come out of their seats in the slotted holes. · The frame mountings must be secure to withstand the weight of the hood and any stresses caused by the occasional side thrust applied to the device. On completion, check that the base is stable, even if the frame is subjected to bending. · In all cases where the ceiling is not strong enough at the suspension point, the installer must provide strengthening using suitable plates and backing pieces anchored to the structurally sound parts. 1 1 2 2 Ducted version air exhaust system Connection When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. · To install a ø 120 mm air exhaust connection, insert the reducer flange 9 on the hood body outlet. · Fix the pipe using the pipe clamps 25 (not provided). · Remove the Metal grease filters (see par. on "Maintenance") and make sure that the power supply Cable is properly inserted in the Suction fan socket. · Take the wires indicated in fig. 1 and pass them through the slot formed on the galvanized diffuser support, as shown in fig. 2. 1 2 · Position the finishing plug 27 over the housing in the diffuser support, fixing it using a screw 12e (2. 9 x 9. 5) and applying the 2 cable clamp elements 26 as indicated in figs. 3 and 4. 4 3 · Connect the Controls Connector fig. · Connect the Lighting Connector fig. · Store both the Connectors in the Protective box 24 and close it with 2 Screws 12e (2. 9 x 9. 5), provided. 6 5 · Remove the protective film from the double-sided adhesive on the connection box, and fix it inside the motor compartment fig. 7. 7 EN 2 20 0 USE L1 L2 L3 L4 L T1 T2 Control panel T3 T4 Button L Function Led Press briefly to turn the lighting system on and off. 2 seconds to turn the lighting system on and off at reduced intensity. Turn the suction motor on and off at speed one. [. . . ] CHANGING THE ACTIVATED CHARCOAL FILTER Resetting the alarm signal · Press any of the buttons except the Light button. Changing the Filter · Remove the Metal grease filters. · Remove the saturated Activated Charcoal filter, as shown in the figure. · Fit the new Filter, hooking it into place. [. . . ]