User manual SMEG KQ45X

[. . . ] The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. USE The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. Never use the hood for purposes other than for which it has been designed. Never leave high naked flames under the hood when it is in operation. [. . . ] Make sure that the position of the grid is correct. Make sure that charcoal filters have been placed inside the hood. 8 7 ELECTRICAL CONNECTION Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. Remove the grease filters (see paragraph Maintenance) being sure that the connector of the feeding cable is correctly inserted in the socket placed on the side of the fan. EN 1 16 6 USE L1 L2 L3 L4 L T1 T2 Control panel T3 T4 Button L Function Led Press briefly to turn the lighting system on and off. 2 seconds to turn the lighting system on and off at reduced intensity. Turn the suction motor on and off at speed one. If the filter saturation alarm is on, this resets it. If the filter saturation alarm is on, this resets it. Press once to turn the suction motor on and off at speed three. Press again to activate intensive speed. This speed is timed to run for 10 minutes. At the end of this time the system will Flashing. automatically return to the speed set before. Suitable to deal with maximum levels of cooking fumes, it is deactivated by pressing any one of the Speed buttons (T1-T2-T3). It cannot be activated if the Delay function is in use. [. . . ] Leds (L1-L2-L3) flash once Activated Charcoal Filter saturation alarm DEACTIVATED. CHANGING THE ACTIVATED CHARCOAL FILTER Resetting the alarm signal Press any of the buttons except the Light button. Changing the Filter Remove the Metal grease filters. [. . . ]