User manual SMEG KSB801

[. . . ] Before any cleaning or maintenance operation, disconnect the hood from the mains by removing the plug or disconnecting the home mains switch. Always wear work gloves for all installation and maintenance operations. The appliance is not intended for use by children or persons with impaired physical, sensorial or mental faculties, or if lacking in experience or know-how, unless they are under supervision or have been trained in the use of the appliance by a person responsible for their safety. Children should be monitored to ensure that they do not play with the appliance. [. . . ] · Fix the upper section of the flue units to the flues support bracket with two screws (Fig. Remount the carbon filter frame and the fat/s filter/s and check the perfect functioning of the hood. Description of the hood Fig. Air outlet (used for filter version only) 8. point lighting (only for the model in Fig. 1G) Operation Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking. Functioning ­ Model with Keyboard A B C D A. on/off aspiration switch and minimum power selection B+C. medium power selection aspiration switch B+D. maximum power selection aspiration switch a b-c-d-e e a a bc b-c-d-e de f a b-c d a. Minimum suction power (c. ), medium maximum (e. ). D - Display showing: · Fan speed (1-3-P). · Change grease filters (grease filter saturation indicator - F) After washing the anti-grease filter, depress knob B for about 3 seconds. The letter F will disappear from the display. · Change activated carbon filters (carbon filter saturation indicator - C). After replacing the charcoal filter, depress knob B for about 3 seconds. The letter C will disappear from the display. · When the led in the lower right side is on, it indicates that the cooker hood is ready for operation ("standby" position), the flashing LED indicates that the timer has been activated for selected speed. The active carbon filter saturation function is not activated. In order to activate the carbon filter saturation indicator, press buttons E and F simultaneously for 3 seconds. Initially, only letter F will fbe displayed, then after the 3 seconds have passed, letter C will be displayed as well, indicating that the carbon filter saturation control system is active. To switch off the system, re-press the same two buttons: letter C appear on display and after 3 seconds letter it disappear and the device will be switched off. [. . . ] Only use halogen bulbs of 20W max (G4), making sure you do not touch them with your hands. Close the lamp cover (it will snap shut). Only use halogen bulbs of 20W max (G4), making sure you do not touch them with your hands. For models shown in Fig. 1+Fig. 4 (A/B/C/D/F/H/I/K/P/Q/S/T/U/V): 1. [. . . ]