User manual SMEG KSEG51-1

[. . . ] The carbon filter should be replaced every 6 months under normal use. Disconnect the hood from the electricity. Remove the metal filters (or its support). Remove exhausted carbon filter, push release button C and pull carbon filter downwards. [. . . ] Put the metal filter or its support back into place. Maintenance Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. Cleaning To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. Wipe brushed stainless steel in the same direction as the brushing to avoid scratching. Clean the external surface of the cooker hood almost once every 10 days. Metal grease filter The grease filter serves to trap grease particles present on cooking fumes. The metal grease filter lasts forever and must be washed either by hand or in the dishwasher (65°C) with suitable detergents. The grease filters must be washed at least once a month. When washed in a dishwasher, the metal grease filter may discolour. It's filtering properties will nevertheless remain unaltered. Let the filter dry without damaging it before putting it back into place. To remove the metal grease filter (according model you own:Fig. Therefore, never use an open flame under the hood. When frying foods, never leave the pan alone because the cooking oil could flare up. -- Please, keep to the provisions of official directives regarding the question of fume discharge. -- The manufacturers refuse to accept any responsibility for damage to the hood or its catching on fire because of failure to observe the above instructions. 11 GB Electric connection (ONLY for UK) WARNING: THIS APPLIANCE MUST BE EARTHED The mains lead of this appliance is fitted with a BS 1363 5 amp fused plug. To change a fuse in this type of plug use an A. S. T. A. Fit replacement 5A fuse into fuse cover. IMPORTANT: The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement is fitted. Correct replacements are identified by the colour insert or the colour embossed in words on the base of the plug. Replacement fuse covers are available from your local Electricity Board Shop. HOW TO CONNECT AN ALTERNATIVE PLUG If the fitted plug is not suitable for your socket outlet, then it should be cut off and disposed of in order to avoid a possible shock hazard should it be inserted into a 5A socket elsewhere. [. . . ] HOW TO CONNECT AN ALTERNATIVE PLUG If the fitted plug is not suitable for your socket outlet, then it should be cut off and disposed of in order to avoid a possible shock hazard should it be inserted into a 5A socket elsewhere. A suitable alternative plug of at least 5 Amp rating e. g. 5 Amp round pin to BS 546 should then be fitted to the cable. The wires in this mains lead are coloured in accordance with the following code:BLUE ­ "NEUTRAL" - "N" BROWN ­ "LIVE" - "L" GREEN AND YELLOW ­ "EARTH" - "E" 1 The GREEN AND YELLOW wire must be connected to the terminal in the plug which is marked with the letter "F" or by the Earth symbol or coloured green or green and yellow. [. . . ]