User manual SMEG KSEG75

[. . . ] Light should be switched ON to improve cooking area visibility. It is advisable to switch on the extractor hood a few minutes before starting cooking and then to leave it running for approximately 5 minutes afterwards to ensure that all odours are extracted. Carbon filter - Fig. 4 (Recirculation mode only) The carbon filter serves to eliminate odours that form during the cooking process. [. . . ] The release the grease filter support from the hood, pull the release buttons B (Fig. To extract the metal grease filter from the support grill, pull from right to left and extract the grease filter. Attention Failure to observe the instructions for cleaning the appliance and changing and cleaning the filters may cause fires. Therefore, we recommend observing these instructions. Replacing the lamp - Fig. Disconnect the hood from the electricity. Open the lamp holder compartment by turning the clasps F for the protective shield for the lamps in the counter-clockwise direction. Replace faulty lamp with one of an equal rating and kind. 10 GB According the cooker hood you own: Lamp 40W max (E14) or Neon lamp 14W max or PL lamp 11W max (model with 1 PL lamp) or PL lamp 9W max (model with two PL lamps) 4. Reclose the protective shield for the lamp. Before calling for repair service because the hood fails to light up, make sure the lamps are well inserted. Installation These minimum distances between hobs and grease filter must be observed: Minimum 650 mm - electric hobs Minimum 750 mm - gas or mixed hobs. Electric connection (Not for UK) Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood It is advisable to call a qualified technician to make the electrical connection. Connect it to a socket which conforms with current regulations. If you intend to connect it directly to the electric mains, remove the plug and fit an approved bipolar switch with a minimum contact opening of no less than 3mm. If the plug is not accessible once it has been inserted in the socket, it will however be necessary to fit an approved bipolar switch with a minimum contact opening of no less than 3mm. Appliance without plug Fit an approved plug or an approved bipolar switch with a minimum contact opening of not less than 3mm. The manufacturers are not liable for any problems caused by the user's failure to observer the above instructions. Warning! -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. -- When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. [. . . ] 3 The BROWN wire must be connected to the terminal which is marked with the letter "L" or coloured red. Systems available Two systems are available: Exhaust mode Vapours are extracted outside through an exhausting pipe that is affixed to the connection ring above the hood. Diameter of the exhausting pipe must be equal to that of the connection ring. In the horizontal runs the duct must be slightly slanted (about 10°) and directed upwards to vent the air easily from the room to the outside. [. . . ]