User manual SMEG KSEIV95X

[. . . ] The route of the flue must be as short as possible. Do not connect the extractor hood to exhaust ducts carrying combustion fumes (boilers, fireplaces, etc. ). If the extractor is used in conjunction with non-electrical appliances (e. g. [. . . ] gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. USE The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. Never use the hood for purposes other than for which it has been designed. Never leave high naked flames under the hood when it is in operation. Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. Do not flamb under the range hood; risk of fire This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. 650 mm min. MAINTENANCE Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. Put back the visor again paying attention that the runners are put correctly into the proper places. Adjust the visor sliding by means of the two screws. Regulating the Vy screws it is possible to align the hood height compared to the closets. When necessary adjust again the hood depth. Place the safety squares above the fixing brackets. Drill the wall and fix the safety squares together with screws and dowels (supplied). Vx Vy Vx Vy 27 5-3 60 mm EN 1 12 2 Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe 120 mm, the choice of which is left to the installer. Fix the pipe in position using sufficient pipe clamps (not supplied). Remove any activated charcoal filters. 120 9 AIR OUTLET IN RECYCLING VERSION Make sure that the hood body has been completely fixed. [. . . ] Fix the pipe in position using sufficient pipe clamps (not supplied). Remove any activated charcoal filters. 120 9 AIR OUTLET IN RECYCLING VERSION Make sure that the hood body has been completely fixed. Make sure that hood is equipped with charcoal filters. ELECTRICAL CONNECTION Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. [. . . ]