User manual SMEG LB5000

[. . . ] The hood is equipped with a top air outlet B for discharge of fumes to the outside (Ducting version exhaust pipe and pipe fixing clamps not provided). Should it not be possible to discharge cooking fumes and vapour to the outside, the hood can be used in the filter version, fitting an activated carbon filter and the deflector F on the support (bracket) G, fumes and vapours are recycled through the top grille H by means of an exhaust pipe connected to the top air outlet B and the connection ring mounted on the deflector F (exhaust pipe and pipe fixing clamps not provided). The models with no suction motor only operate in ducting mode, and must be connected to an external suction device (not supplied). Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. [. . . ] In certain models where it is required to use the cooker hood in the suction version then it is possible to overturn the upper section of the chimney and insert it inside the lower section of the chimney so that the air-exit perforations are not visible. Only for model with optical fibers point lighting (Fig. 1G): Check that the chimneys may be removed to permit access to the optical fibers lamp housing area. Only for the model with control panel on chimney flue (Fig. 1L- 17): Insert the command plate from the motor group through the chimney flue slit from the inside towards the outside (20c). Carry out the connection of the control panel to the command plate. The terminal pivot on the plate MUST correspond to the drill hole on the connection block situated at the back of the control panel. Slide the bottom section of the chimney down until it completely covers the suction unit and slots into the housing provided on top of the hood (Fig. Fix the lower section of the chimney with two screws (only for the model in Fig. Connect the electricity between the two parts (Fig. Fix the flue units definitively to the suction unit with the screws (consult the figure corresponding to the model in possession) (Fig. Speed 3 LED and active carbon filter saturation LED (in this latter case, the LED will flash - See instructions on active carbon filter replacement). Once you have replaced the charcoal filter, press button 1 for about 3 seconds until you hear the acoustic signal (beep). Initially, only LED 4 will flash, then after the 3 seconds have passed, LED 5 will also start flashing, indicating that the active carbon filter saturation control system is active. To switch off the system, re-press the same two buttons: after 3 seconds LED 5 will stop flashing and the device will be switched off. Intensive speed LED Intensive speed ON switch This speed should be used when the concentration of cooking fumes or odours is particularly strong (for example when frying, cooking fish etc. The fast speed will run for about 5 minutes and then return to the speed previously set automatically (1, 2 or 3), or switch off if no speed was selected. To turn off the fast speed, before the end of the 5 minutes, press button 1 or button 2. If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. Then plug it in again and try once more before contacting the Technical Assistance Service. If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. Then plug it in again and try once more before 15 contacting the Technical Assistance Service. [. . . ] Replace the mattress every 3 years and when the cloth is damaged. Insert the pad (i) of activated carbon into the frame (h) and fit the whole back into its housing (j). Prior to touching the light bulbs ensure they are cooled down. Press on the lamp cover and release to open. [. . . ]