User manual SMEG LB5K

[. . . ] Preliminary information for installation of the hood: Disconnect the hood during electrical connection, by turning the home mains switch off. remove the fat/s filter/s and the carbon filter frame. Do not tile, grout or silicone this appliance to the wall. Do not fix chimney flue to furniture or fly over shelves unless the chimney flue can be easily removed, in case maintenance is ever required. [. . . ] To switch off the system, re-press the same two buttons: after 3 seconds LED 5 will stop flashing and the device will be switched off. Intensive speed ON switch This speed should be used when the concentration of cooking fumes or odours is particularly strong (for example when frying, cooking fish etc. The fast speed will run for about 5 minutes and then return to the speed previously set automatically (1, 2 or 3), or switch off if no speed was selected. To turn off the fast speed, before the end of the 5 minutes, press button 1 or button 2. ON lamp button If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. Then plug it in again and try once more before contacting the Technical Assistance Service. Timer for selected speed (visualizes the speed selected and flashing LED on the lower side of the display). This knob permits the operation of the cooker hood for a established period: 20 minutes if the speed selected is 1 15 minutes if the speed selected is 2 10 minutes if the speed selected is 3 5 minutes if the intensive speed P is selected. The letter F will disappear from the display. After replacing the charcoal filter, depress knob A for about 3 seconds. The letter C will disappear from the display. Always press the fan off button A before disconnecting the hood from the mains supply. To disenable the carbon filter signal, repeat this operation again (always with the hood in Off). a beep signals each time the operation is completed. Automatic calibration: the system carries calibration out automatically about every 30 minutes (calibration of the parameters functioning of the sensors). Manual calibration: with the hood in Off, press keys T3 and T4 until the beep. automatic functioning: to activate automatic functioning , press key T3: Led 4 switches on. To return to manual functioning, press key T1, T2 or T3. Sensors test: this happens continuously during automatic functioning. In the case of damage all the Leds flash: in this case, return to manual functioning, pressing keys T1, T2 or T3. Selecting cooking top: this operation optimises the automatic functioning of the hood: with the hood in Off press keys T2 and T3 for about 3 seconds until the cooking top at present in use is seen: gas top - Led 1 on induction top - Led 2 on electric top - Led 3 on. Select the cooking top requested pressing T2, then press T2 and T3 simultaneously for three seconds until the Beep. [. . . ] The appliance is not intended for use by children or persons with impaired physical, sensorial or mental faculties, or if lacking in experience or know-how, unless they are under supervision or have been trained in the use of the appliance by a person responsible for their safety. Children should be monitored to ensure that they do not play with the appliance. Never use the hood without effectively mounted grating. The hood must NEVER be used as a support surface unless specifically indicated. [. . . ]