User manual SMEG LBTA936

[. . . ] Turn the center handle in the clockwise direction until it locks in place. Installation When installed, the distance between the hood and burners must be not less than 65 cm for electric burners or 70 cm for gas or mixed-fuel burners. If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. Do not tile, grout or silicone this appliance to the wall. [. . . ] Do not tile, grout or silicone this appliance to the wall. Do not fix chimney flue to furniture or fly over shelves unless the chimney flue can be easily removed, in case maintenance is ever required. caution This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance. Do not use the cooker hood where the grill is not correctly fixed!The suctioned air must not be conveyed in the same channel used for fumes discharged by appliances powered by other than electricity. The environment must always be adequately aerated when the cooker hood and other appliances powered by other than electricity are used at the same time. flambé cooking with a cooker hood is prohibited. The use of a free flame is damaging to the filters and may cause fire accidents, therefore free flame cooking must be avoided. Frying of foods must be kept under close control in order to avoid overheated oil catching fire. Synthetic Filter (thickness: 10-15 mm): wash the filter in warm water and a biodegradable detergent once a month. Thin Synthetic Filter (approximately 1 mm thick): replace when the coloring from the top is visible on the bottom part. Thin Synthetic Filter (approximately 1 mm thick - without saturation indicator) replace every two months. Removing the Grease Filters (for models wtih grease filter support grates) To remove the dirty grease filter, proceed as follows: a) Remove the pull-out drawer completely and open the ventilation grates that support the grease filters. If special metal filters have been installed, press on the plastic springs (S) to unhook them (Fig. C) When washing or replacing the grease filter, wash the grate as well with warm soapy water. D) Remount the new filter or the old one after it has dried thoroughly. charcoal Filter The charcoal filter serves to eliminate odours that form during the cooking process. Under normal use conditions, the filter should be replaced every 4 months. Remove the grease filters and open the light cover support (or the greas filter support grate). [. . . ] Under normal use conditions, the filter should be replaced every 4 months. Remove the grease filters and open the light cover support (or the greas filter support grate). Turn the center knob on the charcoal filter in the counterclockwise direction and remove the filter from its seat (Fig. Open the light cover support or the back grease filter support grate. [. . . ]