User manual SMEG LC94

[. . . ] Before using the extractor for the first time, you must read the following safety instructions. * Never pull the cable to unplug the extractor. * Do not switch on the extractor if the electricity cable is worn out or has cuts or if there are signs of deterioration around the control panel. * If the extractor stops working or functions abnormally, unplug it from the mains and advise the technical service. [. . . ] * Do not leave gas burning without a pan above it under the hood. * Do not allow grease to accumulate in any part of the extractor, especially in the filter as this COULD PRODUCE A FIRE RISK * Do not flambé food under the hood. * Before installing the extractor consult local rules and regulations in force with respect to current standards on air and fumes. Light switch independent from motor commands. Filters located over cooking area, easily removable for cleaning Extractable group that allows a greater gas capture area. Outlet mouth, locating their ends in the holes provided (Fig. By pushing buttons shown in the figure 1, you will be able to control the functions of the extractor Two achieve better extraction, we recommend switching on the extractor a few minutes before starting to cook (3 - 5 minutes) so that the air flow is continuous and stable when extracting the fumes. Note: * Never use metallic scouring pads or abrasive products that could damage the surface. * Do not use scrapers with metallic surfaces such as knives, scissors etc. To fix the extractor to the kitchen use measures shown on fig. The lower part of the extractor must be located at a minimum height of 60 cm above the hob for electric cookers and 65 cm for gas cookers. if the instructions of a gas cooker indicate a greater distance these must be observed. When the extractor is working at the same time as other non-electrical cooking equipment, the outlet air pressure must not exceed 4 Pa (4 x 10-5 bar). To achieve optimum performance the length of the outlet hose should not exceed 4 meters, or include more than two 90º angles (elbows) Although venting to the outside is recommended, activated carbon filters may be used, which allow the gas to be returned to the kitchen through the outlet pipe. IIf you wish to exchange the front for one matching the kitchen units, follow the following instructions (Fig. * Remove the screws (T) that support the front * Install the new front fixing it with the same screws that held the old one. If something does not work Before seeking technical assistance carry out the following checks first: This appliance must be connected by a competent person, using fixed wiring via a DOUBLE POLE SWITCHED FUSED SPUR OUTLET. We recommend that the appliance is connected by a qualified electrician, who is a member of the N. [. . . ] If something does not work Before seeking technical assistance carry out the following checks first: This appliance must be connected by a competent person, using fixed wiring via a DOUBLE POLE SWITCHED FUSED SPUR OUTLET. We recommend that the appliance is connected by a qualified electrician, who is a member of the N. Should the colour of the wires in the mains lead for the appliance not correspond with the coloured markings identifying the terminal in your spur box proced as follow: * The wire which is coloured blur must be connected to the marked N (Neutral) or coloured Black. * The wire which is coloured brown must be connected to the marked L (Live) or couloured Red This apparatus has the marked CEE in conformity with Standard 2002/92/EC of the European Parliament and the Council about remainers of electrical en electronic apparatuses. [. . . ]