User manual SMEG LD493

[. . . ] For filter version only (with carbon filter mounted inside the exhaust unit) Remount the deflector under the telescopic flue support with two screws (see point "i"); the deflector will reroute fumes inside the room. L) Before positioning the hood, fasten a duct to the connecting ring of the internal exhaust unit and pass the duct through the hood outlet hole. [. . . ] M) Fasten the hood firmly with four screws, two in the upper holes (plus two washers), two in the bottom ones (Fig. O) Finally fasten the telescopic flue with four screws by inserting them from the outside in the two top and bottom holes on the right and left sides of the flue (Fig. The installed appliance must not be less than 65 cm. The duct must be directed straight to the ceiling or to the wall behind. The duct must be slightly slanted upwards (about 10%) in horizontal sections to expel air easily to the outside. 5) and measure the distance between the connecting ring and the point where the exhaust duct is to pass in order to establish the length of the duct. H) Disassemble the upper support B from the telescopic flue by removing the two screws C (one on each side) and put them aside for future use (Fig. I) Remove the two screws joining deflector D to upper support B and put them aside for future use (Fig. To clean the outside of the hood, a cloth moistened with denatured alcohol or neutral liquid detergents. do not use products that contain abrasives. [. . . ] To clean the outside of the hood, a cloth moistened with denatured alcohol or neutral liquid detergents. do not use products that contain abrasives. [. . . ]