User manual SMEG LNS912

[. . . ] mounted on the ring for discharging fumes and vapours externally (Suction Version). Maintenance Where external discharge of cooking fumes and vapours is not Prior to any maintenance operation ensure that the cooker possible the cooker hood may be used in the filter version by hood is disconnected from the electrical outlet. Mounting a carbon filter, a discharge tube should be connected to the ring in order to expel the fumes above the cabinet. [. . . ] Mounting a carbon filter, a discharge tube should be connected to the ring in order to expel the fumes above the cabinet. The Anti-grease filter models without suction motors function only in the suction version May be one of the following if located inside the support and must be connected to a peripheral suction unit (not supplied). Grill: Paper filter should be replaced once a month or sooner, if Installation: The cooker hood must be positioned at least 65 cm coloured on the upper side or when the coloration is visible in the from the cook top for electrical cookers and 75 cm for gas or grill holes. This cooker hood is designed to be fitted to a Sponge filter should be washed with hot soapy water once a cabinet or similar support. Carry out the following instructions for affixing the cooker hood: Metallic filter should be cleaned once a month, with non abrasive Create an opening in the bottom of the cabinet to insert the cooker detergents, by hand or in dishwasher at low temperature and hood, and drill a hole on the top of the cabinet to fit the discharge short cycle. Tube, connect the cooker hood to an external pipe, predispose the When washed in a dish washer, the grease filter may discolour electrical connection, remove the grill or the anti-grease filter, slightly, but this does not affect its filtering capacity. Remove the frame C (if provided) by pressing on the two release To access the grease filter J open the suction grill H via the hooks D (according to the model in possession, the release hook release hooks L and free from the supports K. Flambé cooking with Failure to carry out the basic standards of the cleaning of the a cooker hood is prohibited. The use of a free flame is damaging cooker hood and replacement of the filters may cause fire to the filters and may cause fire accidents, therefore free flame risks. Frying of foods must be kept under close control in order to avoid overheated oil catching fire. Carry Lightbulb replacement: Remove the anti-grease filter supout fumes discharging in accordance with the regulations in force port grill or the anti-grease filter to access the lamp area. reby local laws for safety and technical restrictions. Move the damaged lightbulb and replace with an incandescent oval bulb maximum 40W E14. In the case where model is Operation provided with a halogen lightbulb, replace with halogen bulb of The control panel is supplied with a switch to select the suction 20W (GU5. [. . . ] Move the damaged lightbulb and replace with an incandescent oval bulb maximum 40W E14. In the case where model is Operation provided with a halogen lightbulb, replace with halogen bulb of The control panel is supplied with a switch to select the suction 20W (GU5. Use the higher suction speed for greater levels of cooking All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. [. . . ]