User manual SMEG LSA4845G

[. . . ] This user-friendly manual will provide answers to all your questions about use of the dishwasher. For any other information about use and maintenance of the dishwasher, read the enclosed manual carefully. USER INSTRUCTIONS: useful information is provided for the use of the washing programs and all the dishwasher's functions. User instructions 1. Description of the controls 1. 1 Front panel All the dishwasher controls are grouped on the front panel. 1 2 3 4 5 6 7 8 9 10 ON/OFF BUTTON SELECTION PROGRAM BUTTONS (P1. . . P5) LOAD WASH BUTTON (on some models only) "3/1" OPTION BUTTON (on some models only) DELAY PROGRAM BUTTON (on some models only) START/STOP BUTTON POWER ON LIGHT PROGRAMS INDICATOR LIGHTS INFORMATION DISPLAY RECESSED DOOR HANDLE 1. 2 Information display The dishwasher is equipped with a practical DISPLAY which provides information on the programmed dishwasher functions. User instructions DURATION MINUTES PROGRAMME, NUMBER & SYMBOL LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS CONSUMPTION WATER LITRES (1) POWER KWh (2) 1 2 SOAK Pans and dishes awaiting a further wash Dishes with light dirt Wash immediately after use for dishes with normal dirt Cold prewash Wash at 38C Cold rinse Rinse at 58C Wash at 55C Cold rinse Rinse at 68C Dry Cold prewash Wash at 40C Wash at 55C Cold rinse Rinse at 68C Dry Wash at 70C 2 cold rinses Rinse at 70C Dry Cold prewash Wash at 45C Cold rinse Rinse at 68C Dry Cold prewash Wash at 50C Cold rinse Rinse at 62C Dry Cold prewash Wash at 50C Wash at 65C Cold rinse Rinse at 70C Dry Prewash at 45C Wash at 70C 2 cold rinses Rinse at 70C Dry (**) 6 13 14 0, 03 0, 85 1, 30 QUICK (**) 3 ECO (**) 4 AUTO 40-50 Wash immediately after use for dishes with normal dirt Very dirty pans and dishes, even with dried-on dirt Dishes with normal dirt (***) (***) (***) 5 INTENSIVE (**) 17 1, 50 6 DELICATE (**) 17 1, 15 7 BIO (*) EN 50242 Dishes with normal dirt (**) 15 1, 08 8 AUTO 60-70 Normally soiled dishes, including dried-on residue (***) (***) (***) 9 SUPER Very dirty pans and dishes, even with dried-on dirt (**) 20 1, 70 Only run the soak program with half loads. The HALF LOAD option (3) is available for all programs except the soak program. [. . . ] Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent overheating and malfunction of the appliance. To ensure stability, install integrated or built-under dishwashers only under continuous worktops, and screw them to the adjacent units. To facilitate the installation procedure, the intake and drain hoses can be positioned in any direction; make sure that the hoses are not kinked, crushed or pulled too tightly. Make sure to tighten the locking ring-nut once the pipes have been placed in the direction required. A hole at least 8 cm in diameter is required to allow the power supply cable and pipes to pass. Level the appliance on the floor using its adjustable feet. This operation is essential for ensuring correct operation of the dishwasher. Installing a hob on top of a free-standing dishwasher is absolutely forbidden. Building-in a dishwasher underneath a ceramic hob is absolutely forbidden. A dishwasher can be built-in underneath a conventional hob provided there is no break in the kitchen worktop, and the dishwasher and hob are installed and secured correctly, so that no hazards are generated. The container is situated at the bottom of the dishwasher. After removing the lower basket, unscrew the salt container cap by turning it anticlockwise and pour in the salt using the funnel supplied with the dishwasher. Before replacing the cap, remove any salt residues from around the opening. When using the dishwasher for the first time, in addition to the salt it is also necessary to add one litre of water to the container. Each time the salt container is refilled, make sure that the cap is securely closed. The mixture of water and detergent must never penetrate the salt container, as this would compromise the operation of the regeneration system. In the event of this occurring, the warranty will be invalidated. Only use regenerating salt specially formulated for domestic dishwashers. If using salt tablets, do not fill the container completely. User instructions Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system. When necessary, refill the regenerating salt container before starting the washing program. In this way, the excess saline solution will be immediately removed by the water; the prolonged presence of salt water inside the tank may lead to corrosion. Be careful not to confuse the salt and detergent packages; adding detergent to the salt container will damage the water softening system. 3. 2 Using the rinse aid and detergent dispensers The detergent and rinse aid dispensers are situated on the inner part of the door: the detergent dispenser is on the left, and the rinse aid dispenser is on the right. With the exception of the SOAK program, before every washing cycle it is necessary to add the required amount of detergent to the detergent dispenser. [. . . ] Special products are commercially available t o remove such marks; check that the amount of detergent being used is correct. Certain detergents can be more corrosive than others. check that the cap of the salt container is securely closed, and that the water softening setting is correct. If after following the above troubleshooting instructions the problem persists, call the nearest After-Sales Centre. WARNING: any operations performed on the appliance by unauthorised persons are not covered by the warranty and shall be paid for by the user. User instructions TECHNICAL DATA Width Depth measured flush with the outer edge of the control panel Height (depending on models) Capacity Water supply pressure Electrical characteristics 597 599 mm Free standing: 600 mm Semi-integrated: 590 mm - Fully integrated: 570 mm Free standing: from 850 mm to 870 mm from 890 mm to 910 mm Semi-integrated and fully integrated: from 820 mm to 870 mm from 860 mm to 910 mm 14 Standard place settings min. [. . . ]