User manual SMEG MBR35GRA

[. . . ] Refreshed briefly worn outer clothing made of cotton, artificial fibers and blends with cotton. Use lowest recommended detergent amount. Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. Textiles made of linen, silk, wool and viscose marked as "handwashable". [. . . ] Same as the spin cycle in the "Wool" programme. Drain only - no spinning. ­ ­ ­ ­ ­ ­ ­ ­ Yes Yes Yes Yes ­ ­ ­ ­ i i i i i ­ ­ ­ i 2) i 2) i 2) i 2) i i i i ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ i i i i i i i ­ Max Max Max 400 3) Max Max Max ­ N. B. Please avoid excessive detergent dosing. 5019 612 10245 CONSUMPTION DATA Programme Cotton/Antibacterial Cotton** Cotton** Cotton Cotton** Synthetics Synthetics Delicates Daily load Quick wash 15´ Wool Handwash Handwash Temperature (°C) 95 60 60 40 40 60 40 40 40 30 40 40 30 Load (kg) 5. 0 5. 0 2. 5 5. 0 2. 5 3. 0 3. 0 1. 5 3. 0 3. 0 1. 0 1. 0 1. 0 Water (l) 50* 47 32 47 32 50* 40 50 40 30 55 40 40 without "Rapid" Energy (kWh) 1. 70 0. 89 0. 68 0. 65 0. 52 0. 90 0. 50 0. 55 0. 45 0. 15 0. 55 0. 40 0. 30 Approx. Programme Duration without "Rapid" 2:05 2:45 2:10 2:00 1:45 2:05 1:50 0:45 1:00 0:15 0:45 0:35 0:31 (hrs : min) ­ 2:10 *** 1:45 *** 1:14 0:59 ­ ­ ­ ­ ­ ­ with "Rapid" Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. Water and energy consumption refer to the default setting of the programmes; selecting special options or modifying spin speed or temperature will change the consumption data. The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also "Troubleshooting Guide" in your Instructions for Use). * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Reference Programmes for Energy Label. *** Automatic adaption of programme duration after detection of wash load. START DELAY The "Start delay" button allows the user to run the machine at his convenience, for example at night when electricity is cheaper. · Select programme, spin speed and options. · Press the "Start Delay" button several times to select a delay time of 1, 3, 6, 9 or 12 hours. Check whether the drain hose is kinked or the filter must be cleaned: in the latter case refer to the Instructions for Use ("Removing the Filter"). PROGRAMME END · All the lights of the programme sequence indicator are off, and the "Door open" indication lights up. Turn the programme selector to the "Off/O" position. Open lid and drum and unload the machine. Leave the lid open for some time to allow the interior of the machine to dry. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. Press the "Start(Pause)" button to pause the programme. Select the new programme, any options and another spin speed if you want. Press the "Start(Pause)" button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. [. . . ] Load the machine, close the drum doors and check that they are properly locked. Add detergent and eventual additives as described on the front page and in your Instructions for Use. Turn the programme selector to the desired programme and temperature. The lamp next to the "Start(Pause)" button blinks. SELECT THE DESIRED OPTION(S) Selecting or deselecting an option can be done at any time during the programme. [. . . ]