User manual SMEG P23CL

[. . . ] L30 FAB P23 LINEAR, P23 CLASSIC L23 LINEAR, L23 CLASSIC MODELS WALL MOUNTED HIGH EFFICIENCY GAS FIRE INSTALLATION & USER INSTRUCTIONS It is the LAW that all gas appliances and fittings are installed by a competent person (such as a CORGI registered fitter) and in accordance with the Gas Safety (Installation and Use) Regulations 1998. All instructions must be handed to the user for safekeeping. Revision A - 08/07 Country(s) of destination - GB/IE SMEG (UK) LTD 3 Milton Park Abingdon, Oxon OX14 4RN Phone: +44 (0)870 99 09 907 Fax : +44 (0)870 99 09 337 P23 Linear P23 Classic L23 Linear L23 Classic Please note : Except where otherwise stated, all rights, including copyright in the text, images and layout of this booklet is owned by Smeg (UK) LTD. You are not permitted to copy or adapt any of the content without the prior written permission of Smeg (UK) LTD. L30 Fab The products covered by this booklet are protected under patent GB2275331B. © 2007 Smeg (UK) LTD I N S TA L L AT I O N Section Contents Page No. [. . . ] Recommend that a guard be used for the protection of the young, pets, the elderly and the infirm. Ensure that the fire is fully cold before attempting service. 10. 0 SERVICING A suggested procedure for servicing is detailed below. Remove the decorative frame/glass facia assembly. Remove the glass door assembly (4 screws) and clean carefully. Inspect the burner and the catalyst and clean if necessary with a soft brush. Detach the burner front cover plate by removal of the four retaining screws. Undo the four screws retaining the burner support brackets to the base and rear of the firebox. Remove the control knob and spindle assembly from the valve by removal of the spindle retaining clip. Remove the burner unit, strip off the burner pipes and clean thoroughly. Clean the in-line restrictor, pilot assembly and the burner tube. Do not attempt to remove the pilot injector as this can cause damage. 10. Turn on the gas supply and leak test. Check pilot and burner for good ignition. Refit the glass door assembly, ensuring correct orientation and a good seal. Refit the decorative facia/frame assembly as detailed in section 8. 3. Check the purpose provided ventilation is un-obstructed. Light the fire and test setting pressures. For specific servicing instructions, see relevant sections. © 2007 Smeg (UK) LTD 7 10. 1 SERVICING THE BURNER UNIT AND GAS ASSEMBLY All models : Firstly, remove the decorative frame/glass facia assembly as described in section 8. 3. Remove the inner glass panel, and disconnect the gas connection inside appliance. The gas connections to the gas valve can now be released. Detach the burner front cover plate by removal of the four retaining screws (as shown in figure 9, section 8. 2). Remove the control knob and spindle by pulling outwards. [. . . ] To turn the fire off, keep the knob pressed in, return to the OFF position and release. `OFF' position `SPARK' position `LOW' position `HIGH' position Figure 8 5. 0 COMBUSTION MONITORING SYSTEM This fire is fitted with a combustion monitoring safety device (ODS). If the appliance shuts down during use for no apparent reason then several reasons may be suspected. If a door or window has been opened creating a draught, then pilot disturbance could be the problem and removal of the draught should resolve this. The appliance can then be re-lit in accordance with the previous section. [. . . ]