User manual SMEG PMO800PO

[. . . ] AVAILABLE ACCESSORIES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . FRONT PANEL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . USING THE OVEN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . COOKING WITH THE OVEN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The display will show and (flashing). Turn PT1 to the right or left to set the minutes of cooking (from 00:01 to 23:59). A few seconds after the desired duration is set, will stop flashing and timed cooking will start from that moment. At the end, the word STOP will appear on DSP1, cooking will stop and a buzzer will sound; press PT1 once to deactivate it. If you wish to continue cooking beyond the set time, press PT1 again. The oven will restart normal operation with the cooking settings selected previously. Turn PT2 to "0" to switch off the oven completely. Modifying the set data Once timed cooking has started, its duration can be changed. starts flashing and PT1 can be will turned to change the set duration. A few seconds after the last change, stop flashing, and timed cooking will restart from the new value. To change the preset temperature, wait for to become steady and turn PT1 to the right or left to increase or decrease the cooking temperature. 65 Instructions for the user 7. 7. 3 Programmed cooking Programmed cooking is the function which allows a cooking operation to be started at a set time and then ended after a specific length of time set by the user. Select a cooking function, set the desired cooking temperature or leave the preset temperature (see "7. 6 Selecting functions (pyrolytic models)") and press PT1 twice. PT1 can also be held in the left or right position to increase or decrease the setting more quickly. 67 Instructions for the user 7. 8 Secondary menu (pyrolytic models) The secondary menu appears on first use, after a power failure or by holding PT1 down for 3 seconds with the oven set to OFF (see "7. 4 Operating modes (pyrolytic models)"). The secondary menu enables the user to: Set the time shown on the display (DSP1). 1 P1: OFF / ON Activate or deactivate the child safety lock ( ); this function, after 2 minutes of operation without any actions by the user, locks all the functions and knobs; it is identified by the appearance of on DSP1. To temporarily deactivate locking and modify a cooking programme or select a different function, keep PT1 pressed down until disappears from DSP1. At this point you can make the desired changes, and 2 minutes after the last setting, the lock will be reactivated. To permanently deactivate the lock, you have to enter the secondary menu and deactivate it as described in this paragraph. 2 P2: OFF / ON Activate or deactivate the Show Room function; this function disables all the heating elements so that only the control panel works (to use the oven normally, set P2:OFF). 3 P3: OFF / ON Activate or deactivate the function that allows a maximum consumption of 2300 W. When the child safety lock is activated (P1:ON), if a knob is moved , "bLOC" is displayed on DSP1 for 2 seconds. An action on PT2 also activates the "bLOC" alarm until the function originally selected is restored. 68 Instructions for the user 7. 8. 1 Change the settings in the secondary menu To change the parameters in the secondary menu, use PT1 as instructed below. + Turn PT1 to the right to increase (+) the value or to set the status to ON. ON - Turn PT1 to the left to decrease (-) the value or to set the status to OFF. OFF PUSH Press PT1 to move to the next setting in the menu. After setting P3, press PT1 to resume normal operation of the oven. When making changes, the settings in the secondary menu will appear in the following order: 1 2 3 4 5 setting the hour on the digital clock setting the minutes on the digital clock setting function P1 OFF / ON setting function P2 OFF / ON setting function P3 OFF / ON 69 Instructions for the user 8. COOKING WITH THE OVEN STATIC: As the heat comes from above and below at the same time, this system is particularly suitable for certain types of food. Traditional cooking, also known as static or thermal radiation cooking, is suitable for cooking just one dish at a time. [. . . ] This operation may have to be repeated during the glass removal process if the door is accidentally freed. 84 Instructions for the installer Removing the internal glass panel: · Remove the internal glass panel by pulling the rear part gently upwards, following the movement indicated by the arrows (1). · Then pull the front of the glass panel upwards (2). · Doing this detaches the 4 pins attached to the glass from their slots in the oven door. Removing the middle glass panels: (pyrolytic models) · There are two middle glass panels in pyrolytic models, attached using 4 small locks. [. . . ]