User manual SMEG PV164CBBN

[. . . ] The instructions for use, maintenance and installation, however, remain the same. It is important to conserve this booklet for consultation at any moment. In the case of sale, cession or move, make sure it is together with the product. Read the instructions carefully: there is important information about installation, use and safety. [. . . ] Do not connect the appliance to the mains until the installation is fully complete. The exhausting pipe is not supplied and must be purchased apart. Diameter of the exhausting pipe must be equal to that of the connection ring. In the horizontal runs the exhausting pipe must be slightly slanted (about 10°) and directed upwards to vent the air easily from the room to the outside. If the hood is supplied with active charcoal filter, then it must be removed. Connect the hood and discharge holes on the walls with a diameter equivalent to the air outlet (connection flange). Using the tubes and discharge holes on walls with smaller dimensions will cause a diminution of the suction performance and a drastic increase in noise. Any responsibility in the matter is therefore declined. Use a duct of the minimum indispensible length. Use a duct with as few elbows as possible (maximum elbow angle: 90°). Avoid drastic changes in the duct cross-section. The filter removes the grease and smells from the extracted air before sending it back into the room through the upper outlet grid. The models with no suction motor only operate in ducting mode, and must be connected to an external suction device (not supplied). The connecting instructions are supplied with the peripheral suction unit. 9 Operation Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking. The signalling can be reset by carrying out the abovedescribed procedure twice. First it resets the grease filter signalling, then the carbon filter signalling. In the standard mode the carbon filter signalling is not active. In case the filtering version hood is used, it is necessary to enable the carbon filter signalling. Activation of carbon filter signalling: Set the hood to OFF and keep keys “2” and “3” pressed contemporaneously for 3”. Numbers 1 and 2 flash alternately for 2”. Deactivation of carbon filter signalling: Set the hood to OFF and keep keys “2” and “3” pressed contemporaneously for 3”. Temperature Alarm The hood is equipped with a temperature sensor which activates the motor at speed 3 in case the temperature in the display zone is too high. [. . . ] To deactivate the function before the end of the time, press key “3”, the hood sets at speed 3, when key “2” is pressed the hood turns off. A signal on the display corresponds to each speed: OFF: No signal Speed 1: 1 Speed 2: 2 Speed 3: 3 Speed 4: 4 flashing Display Display Symbols Symbol Speed 1 State Speed 2 Grease filter signalling The grease filter is signalled by the display with number 1 flashing after 40 hours of use. This means that the grease filter needs to be washed. The signalling is visible with the hood in ON state. [. . . ]