User manual SMEG S32STRP/1

[. . . ] Do not cover the ventilation holes at the top and on the sides of the appliance. Do not use any mechanical means or electrical devices to hasten the thawing process when cleaning the freezer compartment. If the supply cord is damaged it must be replaced by the manufacturer, manufacturer service agent or a similarly qualified person, in order to avoid a hazard. Disposal of the appliance should be according to national rules. [. . . ] 1): by turning them clockwise ­ the front of the appliance rises, by turning them counter clockwise ­ it comes down. If the appliance is tilted slightly backward ­ the doors will close by themselves. 1 to unhook the cover fasteners A and pull downward. Replace the light bulb with the same 15 W type light bulb with the E14 lamp holder. After changing the light bulb, put the cover fastener hook in place B and then press upward until its fixing in place. Plug the appliance into the electricity supply socket. CHANGING THE OPENING DIRECTION OF THE DOORS It is recommended that changing the opening direction of the doors should be done with a helper. When changing the opening direction of the doors, YOU CAN NOT lay the refrigerator horizontally. Do the actions below in the order they are listed (fig. Turn off the appliance and pull the plug out of the electricity supply socket. Remove the covers c from the body of the refrigerator and of the inner side of the door. Also remove the upper bracket 6 together with the nut and washers and the spacer under the bracket. Once the bracket is attached to the freezer compartment door, fix it in place on the other side of the refrigerator. Hang the refrigeration compartment door on the axle of bracket 4. Turn the bracket 6 around 180° together with the washers on the axle and the plastic spacer. Remove the axle and the washers and reattach them on the other side of the bracket. Once the bracket 6 is attached to the refrigeration compartment door, fix it in place on the other side of the refrigerator in the uppermost apertures. Use the covers c to cover the bracket and the remaining space. Remove the bolt covers a and the stoppers b. Remove the screws that hold the handles in place. Move the handles to the other side and screw them in place. Place the stoppers into the remaining apertures in the door, and put the screw caps in place. 1), where it evaporates. 66 GB FREEZING OF FOOD STUFFS IN THE FREEZER COMPARTMENT In the freezer compartment, the fast-freeze section is marked with the symbol . [. . . ] · Water has appeared under the appliance. The thaw water collection tray has slipped off the compressor. Place the tray on top of the compressor. · When the appliance door is opened, the rubber sealing gasket pulls out. [. . . ]