User manual SMEG S360X/1

[. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. 2 GB 1. THE NEW WASHING SYSTEM This new washer dryer is the outcome of years of research. [. . . ] Press this button for cottons programmes, the machine will perform an extended wash at 35°C (biological step) thereby offering good washing performance combined with power saving. The machine then continues the cycle at the selected temperature. N. B. : Press the economy cycle button to obtain a maximum washing temperature of 60° C and the elimination of the pre wash cycle. Economy cycle button - e Extra Rinse button In areas with soft water or to improve rinsing, press this button (optional for intensive programmes) to enable the extra rinse function (about 20% more water). Delicates button Press this button to reduce movement of the drum and, consequently, of the washing. Suitable for particularly delicate garments (shirts, silk, curtains, etc. ) Half load button 1/2 If the machine is used with a smaller amount of washing than that indicated in the "Programme Chart", press this button to save water, detergent and electricity. This option should not be used for synthetics or woollens. The recommended doses of detergents should be reduced in proportion to the load. 15 GB N Options enabled LED's These LED's light up when the relative option button is pressed and indicate that the option has been selected. They remain on until the machine switches off or a different selection is made. Press this button to start the selected washing programme. During washing, press the "Start/Pause" button for about 3 seconds to pause the washing cycle. During the pause, the "Time remaining" Led flashes and STOP appears on the display. To resume the washing cycle from where it left off, simply press the "Start/Pause" button again. · Modern detergents and correct washing temperatures are generally sufficient to remove stains from fabrics. However, some stubborn stains, such as grass, fruit, egg, blood, rust and ink, should be pre-treated before washing. Depending on the type of fabric, many stain removers can be found in the shops. Stains should always be cleaned or diluted immediately as the older they get, the more difficult they are to remove. · Garments may be damaged if fabric care symbols are not observed. Wool ­ Only pure wool, identified by or with the label <<shrink-proof machine washable and dryable>> can be machine washed with the specific programme, other types of wool should be hand-washed or dry-cleaned. 5. 2 OPENING THE DOOR The machine is fitted with a safety device that prevents the door from opening while it is working. Before opening the door, wait 1 or 2 minutes after the programme ends ("End" LED on) to allow the safety device to disengage. Make sure there is no water in the tub and that the drum is not moving. Open the door by pressing the "Open door" button on the front panel and pulling it open. Attention!· If the washing programme is interrupted, you will have to wait from 3 to 15 minutes, depending on the temperature of the water, before the door opens. The water may still be boiling if the washing cycle was performed at high temperatures. [. . . ] · When screwing the inlet hose back on to the tap, make sure the filter is correctly positioned. 27 GB 8. TROUBLESHOOTING This product complies with current safety regulations governing electrical equipment. For safety reasons, all technical inspections or repairs must be performed by qualified technicians in order to prevent hazardous situations for users. If the machine does not work, before calling the Service Centre and spending money unnecessarily, check that the operations indicated in this tableU have been performed. Utroubleshooting 1 The machine does not start Check that: the plug is correctly fitted into the socket the door is securely closed the "Start-Pause" button has been pressed. [. . . ]