User manual SMEG S42STRP3

[. . . ] it Indice Avvertenze per lo smaltimento . 6 7 9 10 11 11 12 13 14 14 15 16 Raffreddamento rapido . Massima possibilità di congelamento . Spegnere e mettere fuori servizio l'apparecchio . [. . . ] Switch on super mode, e. g. : S Before placing a lot of bottles in the refrigerator. S To cool drinks quickly. 7 Selection button for refrigerator compartment The freezer compartment temperature can be set from +2 °C to +8 °C. Keep pressing the button until the bargraph has reached the required temperature. 8 Temperature display refrigerator compartment. The numbers on the bargraph cor respond to refrigerator compartment temperatures in °C. The bargraph indicates the set tempe rature. 38 en ed room. The installation location should neither be exposed to direct sunlight nor near a heat source, e. g. If installation next to a heat source is unavoidable, use a suitable insulating plate or observe the following minimum distances to a heat source: 3 cm to an electric cooker. Appliances with fitted handles must be situated at least 55 mm from the wall on the hinge side so that the door can be opened by 90°. Installing the appliance Connecting the appliance Install the appliance in a dry, well ventilat After installing the appliance, wait at least ½ hour before switching on the appliance. During transportation the oil in the compressor may have flowed into the refrigeration system. Before switching on the appliance for the first time, clean the interior (see Cleaning). Connect the appliance to 220 240 V/ 50 Hz alternating current via a correctly installed earthed socket. The socket must be fused with a 10 A fuse or higher. If the appliance is to be operated in a non European country, check on the rating plate whether the indicated voltage and current type correspond to the values of your mains supply. The rating plate is situated in the bottom left hand side of the appliance. The power cord may be replaced by an electrician only. Room temperature The climatic class can be found on the rating plate and indicates the ambient temperatures at which the appliance can be operated. Climatic class SN N ST T Permitted ambient temperature +10 °C to 32 °C +16 °C to 32 °C +16 °C to 38 °C +16 °C to 43 °C Switching on the appliance Press the On/Off button. To stop the warning signal, press the Alarm button. The Alarm button remains lit until the set temperature has been reached. Ventilation Fig. 3 The air on the rear panel of the appliance heats up. Otherwise, the refrigerator must work harder. This will increase the power consumption. Therefore: Never cover or block ventilation openings! 39 en Selecting the temperature Keep pressing the temperature selection button for the refrigerator compartment or freezer compartment until the required temperature is indicated on the bargraph. [. . . ] Fault Temperature differs greatly from the set value. Possible cause Remedial action In some cases it is adequate to switch off the appliance for 2 minutes. If the temperature still differs try again after an hour. If the temperature is too high wait a few hours and check whether the temperature has approached the set value. [. . . ]