User manual SMEG S64S

[. . . ] 37 BEFORE INSTALLATION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37 DESCRIPTION OF THE CONTROLS ON THE FRONT PANEL. . . . . . . . . . 38 USE OF THE OVEN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40 USE OF THE PIZZA FUNCTION (ON SOME MODELS ONLY) . . . . . . . . . . [. . . ] At this point it is also possible to select the cooking function required and wait for the buzzer to sound, indicating that the cooking time is over. You can now set an additional cooking time by turning PT1, or return to display of the current time by pressing PT1 twice. Turn PT2 to the "0" symbol to switch off the oven. The minute minder also works with no function set. 41 Instructions for the user Warning. The minute minder does not stop the cooking process. It only warns the user that the preset number of minutes have passed. To switch the oven off, turn PT2 to the "0" symbol. Modifying the data set Once the countdown has started it is possible to change its duration during cooking. When the symbol is steady, press PT1 once. The symbol starts flashing and PT1 can be turned to change the set duration. A few seconds after the last change, the symbol will stop flashing, and the countdown will restart from the new value. After setting P3, press PT1 to resume normal operation of the oven. 45 Instructions for the user 7. 7 Cooling system The appliance is equipped with a cooling system which comes into operation as soon as a cooking function starts. The fans cause a steady outflow of air from above and below the door which may continue for a brief period of time even after the oven has been turned off. 7. 8 Inside light The oven light comes on: · when the function knob is turned to any function. · when the PT1 knob is turned to off. Turning it left causes it to switch 46 Instructions for the user 8. USE OF THE PIZZA FUNCTION (ON SOME MODELS ONLY) This appliance is equipped with a function designed specifically for cooking pizzas. This function is identified by the symbol on the oven function knob. With the oven cold remove the circular cover from the bottom of the oven, leaving the pizza plate uncovered. Position the oven function knob on the symbol and the thermostat knob on 280°C. Pre-heat in this condition until the thermostat light switches off; then place the pizza onto the plate. For the best cooking results, it is normally not necessary to exceed the 3-4 minutes, although this time may vary according to the dough used or the tastes of the consumer. 8. 1 · Precautions for using the pizza plate Never use the pizza plate except as described above (for example, never use it on gas or ceramic hobs, or on ovens not designed to take this accessory). The pizza plate may be left in place while conventional cooking operations are in progress. [. . . ] If your oven also has a middle glass pane (figure 2) this can be extracted simply by lifting it upwards. After having carried out the cleaning, first of all replace the middle glass panel (if your oven has one), and then position the internal glass hinging it, as shown in figure 3, on the grooves of the oven door (see part. When the glazing has been positioned on the door, exert a slight pressure on the four fixing pins. If the door should close during these operations, simply relock one of the hinges as described in point "12. 2 Removing the door". [. . . ]