User manual SMEG S800TL1

[. . . ] CONTENTS BEFORE USING THE WASHING MACHINE FIRST WASH CYCLE PRECAUTIONS AND GENERAL RECOMMENDATIONS DESCRIPTION OF THE WASHING MACHINE PREPARATION OF THE WASHING DETERGENTS AND ADDITIVES PROGRAMME SELECTION CLEANING THE FOREIGN BODY TRAP DRAINING RESIDUAL WATER CARE AND MAINTENANCE TROUBLESHOOTING GUIDE AFTER-SALES SERVICE TRANSPORT AND HANDLING INSTALLATION ELECTRICAL CONNECTION BEFORE USING THE WASHING MACHINE 1. Remove the packaging and check a. Remove the top protection and the protective corners. Remove the bottom protection by tilting and turning the washing machine on one rear bottom corner. Open the lid by pressing it slightly down while raising the handle. [. . . ] Refit the blade from inside the drum: Position the plastic tip above the hole on the right side of the drum. Then slide the plastic blade from right to left until it clips. Close the drum flaps again, turn the drum through half a turn and check the positioning of the blade at all its anchorage points. Plug the washing machine in again. 3 4 4 7 GB 11 Washing machine exterior and control panel · Clean with a soft damp cloth. · If necessary, a neutral household cleaner can be applied (do not use aggressive or abrasive products). Lid seal · Clean from time to time with a damp cloth. Water inlet hose(s) · Check the hose regularly for brittleness and cracks. Replace if necessary. TROUBLESHOOTING GUIDE This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and allow you to react appropriately. Often, however, the faults detected are small enough to be solved in a matter of minutes. For example: Reconnect the washing machine. Turn on the machine to continue with the programme (do not add detergent for this programme). *The washing machine does not drain out the water. Switch off the washing machine and unplug it. Check whether: · the "Rinse Hold" button is pressed. · the drain hose is kinked (see "Installation"). · the pump impeller is obstructed (see "Cleaning the foreign body trap"). · the water in the drain hose is frozen. If water has remained in the drum, you can drain it by following the instructions in the chapter "Draining residual water". IMPORTANT: Before draining, allow the wash water to cool down. Turn on the machine to continue with the programme (do not add detergent for this programme). If the fault re-occurs, contact After-Sales Service (see "After-Sales Service") *The washing machine does not start, no lamp lights up. Check whether: · the washing machine is plugged in. · the wall socket is functioning correctly (use a table lamp or similar). *The washing machine does not start, but the pilot lamp is on. Check whether: · the washing machine lid is properly closed. · the water tap is open. *The washing machine stops during the programme. Check whether: · the "Rinse Hold" button is pressed: terminate this option by pressing the button again. · the pump/foreign body trap is blocked (see "Cleaning the Foreign Body Trap"). · the Water stop could be activated (see "Water stop fault"). *Detergent and additive product residues remain in dispenser at end of wash. Check whether: · the detergent dispenser is properly installed and is not blocked (see "Care and maintenance"). · the foreign body trap in the water inlet hose is not blocked (see "Care and maintenance"). *Insufficient or no water supply. Switch off the washing machine and unplug it. [. . . ] END OF WASH CYCLE · The programme selector knob is in the Stop position. Press the "On/Off" button to switch off the machine. Wait for the lid to unlock (about 1 minute). Open the lid and the drum doors and unload the machine. CHANGE THE PROGRAMME DURING THE WASH CYCLE 1. [. . . ]