User manual SMEG SA305X

[. . . ] 8. INSTRUCTIONS FOR SAFE AND PROPER USE________________ 4 INSTALLATION __________________________________________ 6 DESCRIPTION OF CONTROLS _____________________________ 9 USE OF THE OVEN ______________________________________ 14 AVAILABLE ACCESSORIES _______________________________ 15 COOKING HINTS ________________________________________ 16 CLEANING AND MAINTENANCE ___________________________ 19 EXTRAORDINARY MAINTENANCE _________________________ 21 INSTRUCTIONS FOR THE INSTALLER: these are intended for the qualified technician who must install the appliance, set it functioning and carry out an inspection test. INSTRUCTIONS FOR THE USER: these contain user advice, description of the commands and the correct procedures for cleaning and maintenance of the appliance. 3 Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE OVEN. WE ADVISE CAREFUL READING OF THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE OVEN. [. . . ] At the end of the countdown, the oven has to be switched off by hand, by turning the thermostat and the function selector to 0. 1 2 11 Instructions for the user 3. 2. 3 Programming Cooking duration time: the 2nd button can be used to set the cooking time. Before setting it, turn the thermostat to the cooking temperature of choice and the function selector knob to any setting. To set the cooking time, proceed as follows: Press the key for 1/2 seconds; the pointer will move to position 12 (Fig. Use the and keys to set the cooking time; key is pressed, 1 minute will be whenever the added to the cooking time, and every 12 minutes a 1 new inside segment will light up (figure 2 shows a cooking time of 1 hour). Once the required time has been set, cooking will start about 6 seconds after the last time the or . Once cooking has started, the display will show the current time, represented by the constantly on 2 segments, and the minutes left until cooking finishes, represented by the flashing segments (every flashing segments indicates 12 minutes of cooking time left). When the end of the cooking time is reached, the timer will switch off the oven heating elements, the beeps will start and the numbers on the dial will flash. The cooking time can also be reset by deleting the program set; for 1 or 2 seconds will delete the time set pressing the central key and the oven will have to be switched off by hand. Caution: cooking times of more than 6 hours cannot be set. - - - 12 Instructions for the user Cooking start: as well as setting a cooking duration time, the user can also set the cooking start time (up to 12 hours after the current time). To set the cooking start/end time, proceed as follows. Set the cooking duration time as described in the previous point. or keys are Within 6/7 seconds after the last time the key to set the cooking start time. The display pressed, press the will show the current time with the inside segments indicating the cooking end time illuminated. Use the and keys to set the cooking start time. 6/7 seconds after the last time a key is pressed, the display will show the current time and the cooking start and end times, indicated by the illuminated inside segments. The segments on the display will be constantly on until the current time is the same as the cooking start time; as soon as the current time reaches the cooking start time set, all the inside segments will start to flash, indicating that the oven has started cooking. When the end of the cooking time is reached, the timer will switch off the oven heating elements, the beeps will start and the numbers on the dial will flash. To reset the entire program set, keep the central key pressed for 1 or 2 seconds: if cooking has already started the oven will have to be switched off by hand. The image on the right shows an example of programming: the current time is 7. 06 and cooking is programmed to start at 8 o'clock and finish at 9. At 8 o'clock, the inside segments between 8 and 9 will start to flash and the hour pointer will remain still. Caution: for the oven to start cooking after the programming procedure just described, the thermostat and function selector must be properly set on the temperature and function required. - 13 Instructions for the user 4. [. . . ] · The oven should be operated at the maximum temperature for about 15/20 minutes after using specific products, to eliminate the residues deposited inside the oven. · For easier cleaning, the door can be removed (see P. 8. 2) 7. 2. 1 Self-cleaning liners The oven is equipped with continuous self-cleaning enamelled liners. These liners make the oven easier to clean and ensure its efficiency over time. [. . . ]