User manual SMEG SC100EBO

[. . . ] PRECAUTIONS FOR USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . DISPOSAL INSTRUCTIONS - OUR ENVIRONMENT POLICY . . . . . . . . . . . . . SAFETY PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GET TO KNOW YOUR OVEN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Turn the THERMOSTAT-TIMER KNOB towards the symbol to increase the hours at a rising speed in a repetitive cycle from 00 to 23. To increase the hour value one hour at a time, turn the knob towards the symbol several times in succession. Once the current hour has been set, release the knob from the symbol. A few seconds later the current number of hours will appear on the display in steady mode, while the minutes figures will flash. Turn the THERMOSTAT-TIMER KNOB towards the symbol again to increase the minutes in a repetitive cycle from 00 to 180. Once the correct number of minutes has been set, release the knob from the symbol. A few seconds later the current time will appear on the display in steady mode, with the two separator dots flashing every second. You will also note that the displays luminosity dims. To access the time setting mode again with the oven in stand-by status, simply hold the thermostat knob turned to the symbol for 5 seconds, until the display starts to flash, and repeat the operations just described. 7. 2. 2 Setting the cooking temperature Each of this oven's functions has a preset cooking temperature. When the FUNCTION KNOB is turned to any function (except ) a figure showing the temperature preset for that function appears on the display (e. g. During preheating, the degrees Centigrade symbol only will flash, while the numbers remain in steady mode. Once preheating is over, the degrees Centigrade symbol will also switch to steady mode. The cooking temperature can be changed at any time by turning the THERMOSTAT-TIMER knob to the symbol or holding it in this position. If the knob is held in position, the temperature will increase at a rising speed in 5°C steps starting from the preset value. To reduce the cooking temperature from the preset value, increase the value to the full scale setting (250° or 275° depending on the chosen function), release the knob from the symbol and turn it to the symbol again. The count will restart from the minimum value of 50°C. Warning: if you change function during a cooking operation, the new temperature recommended for the new function will be displayed; it might be different from that set for the previous function. 37 Instructions for the User 7. 2. 3 Setting the cooking duration A cooking duration from 1 to 180 minutes can be set for every function except . The duration can only be set after cooking has started, by turning the THERMOSTAT-TIMER knob to the symbol and holding it in this position for a few seconds. The message will start to flash on the display. Hold the knob in this position and the cooking duration will increase, minute by minute, to 180 minutes. If you wish to set a shorter duration, when the value reaches the full scale release the knob and turn it back to the symbol to start again from 1 minute. [. . . ] EXTRAORDINARY MAINTENANCE Occasionally, the oven will require minor servicing procedures or the replacement of parts subject to wear and tear, such as gaskets, light bulbs, etc. The specific operations for each procedure of this kind are provided below. Before carrying out any operation involving access to live parts, disconnect the appliance from the electricity supply. 12. 1 Changing the light bulb Remove the protective cover A by unscrewing it anti-clockwise and replace the bulb B with another of the same type (25 W). Replace the protective cover A. Use only light bulbs approved for ovens (T 300°C). [. . . ]