User manual SMEG SCB66MFX

[. . . ] IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION TEST OF THE APPLIANCE, FOLLOWING THE INSTRUCTIONS BELOW. SHOULD THE APPLIANCE NOT FUNCTION, DISCONNECT IT FROM THE SUPPLY AND CALL THE NEAREST TECHNICAL ASSISTANCE CENTRE. WHEN NOT IN USE, MAKE SURE THAT THE CONTROL KNOBS ARE IN THE CORRECT (OFF) POSITION . NEVER PUT INFLAMMABLE OBJECTS IN THE OVEN: THEY COULD BE ACCIDENTALLY LIGHTED AND CAUSE FIRES. THE I. D. PLATE WITH TECHNICAL DATA, SERIAL NUMBER AND BRAND NAME IS POSITIONED VISIBLY IN THE STORAGE COMPARTMENT. [. . . ] Regular flashing means that oven temperature is being constantly maintained at the programmed level. ELECTRIC OVEN CONTROL KNOB Each of the functions listed below can be used (except the oven light) only together with the correct temperature thermostat regulation as described on page 9 of this manual. OVEN LIGHT GRILL ELEMENT + VENTILATION UPPER AND ELEMENT GRILL ELEMENT LOWER HEATING LOWER HEATING ELEMENT + VENTILATION VENTILATED HEATING ELEMENT + VENTILATION THERMOSTAT INDICATOR LIGHT When this light comes on, the oven is heating up. When this light goes out, the preset heating temperature has been reached. When the light flashes, the temperature inside the oven is steady at the set temperature. 39 Instructions for the user 4 USE OF THE COOKING HOB 4. 1 Cooking zones The appliance features 4/5 cooking zones of different diameter and power. Their position is clearly indicated by circles and the heat given off is defined by the markings on the glass surface. The 5 cooking zones are of the HIGH-LIGHT type and come on after a few seconds of being activated. Heating intensity can be adjusted by means of the knobs located on the front panel from a minimum to a maximum. The cooking zones marked by two concentric circles / ) feature ( )and by a circle + fish-kettle ( double heating either within the inner circle or both circles. The 4 signal lamps located between the cooking zones come on when the temperature of one or more of the heating zones exceeds 60°C. The lamps go off upon temperature dropping to below approximately 60°C. When using for the first time, it is advisable to heat up the cooking hob to its maximum temperature for enough time so as to burn off any possible oily manufacturing residues, the smell of which could otherwise be absorbed by the food. For best results and energy saving, only use receptacles suitable for electric cooking: · · · The bottom of the receptacles must be very thick and perfectly flat; before placing on the cooking hob, make sure that it, as well as the cooking hob itself, are perfectly clean and dry. To avoid scratching of the cooking hob, never use cast-iron receptacles or receptacles with a rough bottom. To avoid waste of energy, make sure that the diameter of the receptacle bottom is the same as that of the circle marked on the cooking hob. Take care not to spill sugar or sweet mixtures on to the cooking hob when hot. Never place materials or substances which may melt (plastic or aluminium foil) on to the cooking hob. In the event, promptly switch off and remove the molten material with the scraper provided while the top is still warm to prevent it from being damaged. Failure to instantly clean the glazed ceramic hob could lead to encrustations which are impossible to remove once the hob has cooled down. Important. Beware of children in the vicinity as the signal lamps indicating residual heat are out of sight to them. In fact, even after having been turned off, the cooking hob remains hot for a certain period of time. Make sure that children never touch the cooking hob. 40 Instructions for the user 5 USE OF THE OVEN For those models with electronic programmer, before using the oven make sure that the display shows the symbol . For those models with analogue clock and timer, place on the symbol . 5. 1 Warnings and general advice Before using the oven for the first time, pre-heat it to maximum temperature (250°C) long enough to burn any manufacturing oily residues which could give the food a bad taste. After a power failure, the display will flash at regular intervals showing . To regulate, refer to paragraph "6 ELECTRONIC PROGRAMMER". Oven accessories which may come into contact with foods are made from materials complying with the requirements of the current directive. During cooking, do not cover the bottom of the oven with aluminium or tin foil and do not place pans or oven trays on it as this may damage the enamel coating. [. . . ] Rinse and dry. 7. 4 Door glass The door glass should always be kept clean. In case of tough spots, clean with a damp sponge using regular detergent. 46 Instructions for the user 8 EXTRAORDINARY MAINTENANCE The oven may require extraordinary maintenance or replacement of parts subject to wear such as seals, bulbs, and so on. The following instructions describe how to carry out these minor maintenance operations. Before any intervention, disconnect the power supply of the device. 8. 1 Replacement of light bulb Remove cover A by twisting anticlockwise, replace bulb B with another similar bulb (25 W). [. . . ]