User manual SMEG SCP171XU

[. . . ] UNDERSTAND SIGNAL WORDS A signal word ­ DANGER, WARNING, or CAUTION ­ is used with the safety-alert symbol. DANGER identifies the most serious hazards. It means you can be killed or seriously injured if you do not immediately follow the instructions. [. . . ] If this appliance is connected to an outside electrical power source, it must be grounded in compliance with local laws, or, if no local laws exist, in compliance with the national ANSI / NFPA 70 code of electrical regulations. Make sure that the voltage and dimensions of the supply line correspond to the information indicated on the model/serial rating plate. A multi-polar cut-out must be available on the supply line with a contact opening distance equal to or greater than 3mm, located in an easily accessible position near the appliance. Do not attempt to repair or replace any part of your oven unless it is specifically recommended in this manual. All other service procedures should be performed by a qualified technician. This oven is not suitable for installation and use in mobile homes or campers. See the "Electrical Requirements" section. It is the customer's responsibility: - To contact a qualified electrical installer, - To ensure that the electrical system is adequate and in compliance with the national ANSI / NFPA 70 ELECTRICAL CODE ­ latest edition ­ Or the CANADIAN ELECTRICAL CODE, C22. 11 ­ 1982 and C22. 2 No. 01982 ­ or latest edition ­ and all local codes and ordinances. IMPORTANT: Observe all government codes and ordinances. · · · · · 5 Instructions for the Installer 3. PREPARING THE BUILT­IN OVEN EXCESSIVE WEIGHT HAZARD WARNING - Use two or more people to move and install the oven Failure to do so can result in back or other injury. IMPORTANT: This appliance must be integrated in any cabinets made of material which is heat resistantup to temperatures of 194°F-90°C. Keep to the dimensions indicated in pictures 1, 2, 3. For under-worktop positioning, keep to the dimensions indicated in pictures 1 and 3. For column positioning, keep to the dimensions indicated inpictures 1 and 2. [. . . ] Connect the neutral wire to the branch circuit's neutral conductor in the usual manner: - Disconnect the ground from the neutral at the free end of the conduit, - Use the grounding terminal or lead to ground unit, and - Connect the neutral terminal or wire to the branch circuit neutral in the usual manner (see pic. 2 below) 7 Instructions for the Installer US INSTALLATION ONLY ­ 3 WIRE BRANCH CIRCUIT Refer to figure 1, where local codes allow the connection of the ground wire from the applliance to the branch circuit neutral wire (white wire): The ground wire must be connected first; If local codes permit, connect the green or yellow-green ground wire from the appliance and the white wire from the appliance to the branch circuit neutral wire (white wire). Connect the red and black leads from the oven to the corresponding leads in the junction box. - UL/CSA listed wire connector fig. 1) US INSTALLATION AND CANADIAN INSTALLATION ­ 4 WIRE BRANCH CIRCUIT Refer to figure 2, Disconnect the green or yellow-green from the white lead. [. . . ]