User manual SMEG SE133ATF1

[. . . ] - The installation and maintenance tasks listed in this section must be performed exclusively by qualified personnel in compliance with the provisions in force. - The unit should be used solely for its intended function, this being domestic cooking. All other uses are to be considered improper and therefore dangerous. - The manufacturer cannot be held liable for any damage to objects or injury to persons resulting from the incorrect installation or maintenance or improper use of the unit. [. . . ] If not, take the unit to a materials disposal centre, finding out the address from your local council. 27 2. 1) 1 Normal hotplate 2 Rapid hotplate 3 Normal hotplate 4 Rapid hotplate B. DESCRIPTION OF CONTROLS (P) POWER CONTROL KNOB FOR MONO COOKING ZONE HEATING ELEMENTS (Fig. 2) * Ø 145 mm Ø 180 mm Ø 180 mm Ø 145 mm - 1000 W - 2000 W - 1500 W - 1500 W Turn the knob clockwise. The following symbols are marked underneath the knob: 0 = radiant heating element off from 2 to 12 = from minimum to maximum power * N. B. : Fitted hobs with separate controls will only work if installed with the fitted oven, as the radiant heating element control knobs are situated on the oven control panel. FIG. TECHNICAL INFORMATION The installation and maintenance tasks listed in this section must be performed exclusively by qualified personnel in compliance with the provisions in force. The manufacturer cannot be held liable for any damage to objects or injury to persons resulting from the incorrect installation of the unit. After removing the external pack and internal packaging on the mobile parts, check that the unit is complete. If you have any doubts, do not use the unit and contact your nearest Assistance Centre. The stainless steel parts are already fitted on the unit, protected with plastic film. This protective film must absolutely be removed before using the unit. The recess for the oven in the cabinet can now be completed, making sure that the power supply cable is suitably positioned and does not come into contact with any hot parts. FIG. MAINTENANCE Disconnect the unit from the mains power supply before carrying out any maintenance work. CHANGING COMPONENTS To change any of the components housed in the hob, proceed as follows: - Partially withdraw the oven from its housing (see instructions handbook, Instructions for installer - Part 3 section "C. - Unplug the connectors that connect the hob to the oven (see oven instructions, as above). - Unscrew the screws "F" (fig. 8) on the fasteners that secure the hob to the cabinet - Remove the hob from the cabinet, turn it over and unscrew the screws on the hob base panel. On completing these operations, proceed with changing the parts. Go through the above steps in reverse order to reassemble the hob. 31 4. HOW TO USE THE HOB The hob has four cast iron hotplates of different power and dimensions for all types of cooking. Each knob on the oven control panel has a diagram printed above it showing which cooking zone or hotplate (fig. Switching on the electric hotplates The hob has two kinds of electric hotplate: normal and rapid. [. . . ] Food that has to be brought to the boil. Grilling meat, chops, steaks and cooking large quantities of boiled food. Bringing large quantities of water to the boil. Frying. 4 4 Gentle 6 8 8 Slow Medium 10 12 12 Strong Vigorous E. [. . . ]