User manual SMEG SE2662TC

[. . . ] 9. INSTRUCTIONS FOR PROPER USE ______________________________________ 19 SAFETY INSTRUCTIONS _______________________________________________ 20 KNOW YOUR HOB ____________________________________________________ 21 BEFORE FIRST USE___________________________________________________ 21 COOKING ZONES_____________________________________________________ 22 DESCRIPTION OF CONTROL ON THE FRONT CONTROL PANEL______________ 23 USE OF THE COOKING HOB____________________________________________ 24 CLEANING AND MAINTENANCE _________________________________________ 28 SOMETHING WRONG?________________________________________________ 28 10. INSTALLATION _______________________________________________________ 29 INSTRUCTIONS FOR THE USER: these contain user advice, description of the commands and the correct procedures for cleaning and maintenance of the appliance. INSTRUCTIONS FOR THE INSTALLER: these are intended for the qualified technician who must install the appliance, set it functioning and carry out an inspection test. 18 Instruction for proper use 1. INSTRUCTIONS FOR PROPER USE ELECTRICAL CONNECTION: PLEASE REFER TO INSTALLATION INSTRUCTIONS FOR THE GAS & ELECTRICAL SAFETY REGULATIONS AND THE VENTILATION REQUIREMENTS. [. . . ] 7. 1. 3 Description of symbols REAR LEFT REAR RIGHT FRONT LEFT FRONT RIGHT 7. 1. 4 Residual heat The 4 warning lights located between the cooking zones come on when the temperature of one or more of the zones exceeds 60°C. The lights go off upon temperature dropping to below approximately 60°C. 7. 1. 5 Switching off To turn off, return the knob to 0. 24 Instructions for the user 7. 2 Hobs with touch-control buttons When an icon is pressed the unit beeps to confirm. To operate the panel of the hobs equipped with touch-controls, lightly press the icons printed on its surface. On first connection to the electrical mains, an operating check will be carried out automatically and all the indicator lights will come on for a few seconds. 7. 2. 1 Switching on the hob symbol is pressed twice the hob When not in use, all hob components will be switched off. The power level must be set within 20 seconds after the sectors light up; otherwise the hob will switch off automatically. 7. 2. 2 Single cooking zones The associated cooking zone is indicated close to each control zone. For example, the symbol identifies the knob that controls the rear right-hand cooking zone. and After turning on the hob as described in paragraph "7. 2. 1 Turning on the Hob", press the keys to activate the cooking zone (display indicating 0) and adjust the power at which it should operate. The power settings range from a minimum of 1 to a maximum of 9. You must adjust the power within 5 seconds from when the cooking zone is activated, otherwise it will automatically deactivate. and buttons in the following way to activate the cooking zone and adjust its power: Press the 1. press the symbol (0 appears on the display: this means that the cooking zone is activated); 2. by continuing to press the symbol , you can adjust the power of the cooking zone up to the maximum value of 9; , you adjust the power of the cooking zone down to the 3. if you instead press the symbol minimum value of 1. 7. 2. 3 Dual cooking zones To activate heating of the dual cooking zone, once power 9 is reached by following the instructions provided in paragraph "7. 2. 2 Single cooking zones", press the again. Now the maximum power of the cooking zone is activated, and is shown by the LED light turning on next to the number indicating and to adjust the power of the dual cooking zone to the operating power. 7. 2. 4 Triple cooking zones To activate heating of the triple cooking zone, once power 9 of the dual cooking zone is reached by following the instructions provided in paragraph "7. 2. 3 Dual cooking zones", press the again. Now the maximum power of the triple cooking zone is activated, and the LED indicating the operating power remains fix. Press and to adjust the power of the triple cooking zone to the desired value. on the symbols 7. 2. 5 Heating zone This zone, which is present only on some models in the range, keeps the area inside the dashed line at a temperature of approximately 90°C. It is used for warming dishes up or keeping them hot. [. . . ] THE SOCKET MUST BE ACCESSIBLE AFTER THE APPLIANCE HAS BEEN BUILT IN. IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION TEST OF THE HOB, FOLLOWING THE INSTRUCTIONS. IF THE HOB FAILS TO OPERATE, AFTER CHECKING THAT YOU HAVE CARRIED OUT THE INSTRUCTIONS CORRECTLY, DISCONNECT THE APPLIANCE FROM THE ELECTRICAL MAINS AND CONTACT YOUR NEAREST SERVICE CENTRE. IF A PLUG AND SOCKET CONNECTION IS BEING USED MAKE SURE THAT THE PLUG AND SOCKET ARE COMPATIBLE. [. . . ]