User manual SMEG SE430EB

[. . . ] To thaw frozen foods and prepare stews, heat to boiling point or simmer. To bring large amounts of liquid to the boil. 2 3 USE WARNINGS: When the plate is switched on for the first time, or if it has remained unused for a long period, it should be dried for 30 minutes on switch position n° 1. This will eliminate any moisture that may have been absorbed by the insulating material. [. . . ] 3 4 CLEANING IMPORTANT: Always disconnect the appliance from the electricity main before carrying out any cleaning operation. WARNINGS: - Correctly preserve the plate after use by treating it with special products, easily available on the market. This will keep the surface of the plate clean and bright. The operation will also prevent the formation of rust. - Any liquid overflowed the pans, must be always remove with a rag. - Don't use steam jets for the equipment cleaning. 3) HOTPLATE If you want to preserve the surface clean and bright, periodically wash the hot plate with lukewarm soapy water. Following this, all parts should be thoroughly rinsed and dried. Never wash them while they are still warm and never use abrasive powders. Do not allow vinegar, coffee, milk, salted water, lemon or tomato juice from remaining in contact with the enamelled surfaces for long periods of time. 5 INSTALLATION Installation and maintenance must only be carried out by a qualified installer. Incorrect installation could cause damage to persons, animals and property for which the manufacturer cannot be held responsible. - Overturn the hob and correctly position seal "E" (fig. This plug should be able to bear the load indicated on the data label. Connect the wires according to the diagram in fig. 8, remembering to comply with the following instructions: Letter L (live) = brown wire; Letter N (neutral) = blue wire; Earth symbol = yellow-green wire. - The powering cable must be positioned so that it is never able to reach an overtemperature of 75 K in any part. - Never use reductions, adapters or shunts for the connection since these could cause false contacts and dangerous overheating. - The outlet must be accessible after the built-in. When the appliance is connected straight to the electricity main: - Install an omnipolar cutout between the appliance itself and the main. This circuit-breaker should be sized according to the rating of the appliance and the opening between its contacts should be at least 3 mm. - Remember that the earth wire must not be cutout by the switch. - Alternatively, the electrical connection may also be protected by a high sensitivity differential switch. Installers are strongly advised to connect the yellow- green earthing wire to an efficient earthing system. [. . . ] To reassemble the appliance repeat the inverse process. 8) REPLACING THE ELECTRICAL COMPONENTS For access to the various parts, remove the hotplate from the top of the cabinet. Then overturn it, unscrew screw "Z" and remove under part. After these actions is possible to work on the plates, commutators, clamps and input cable. 9) TECHNICAL CHARACTERISTICS OF THE ELECTRICAL COMPONENTS To facilitate the job of the installer we present a scheme with the characteristics of the components. POWER OF ELECTRICAL COMPONENTS DENOMINATIONS W Denominations Normal plate Ø 145 mm Normal plate Ø 180 mm W 1000 1500 TYPE AND SECTION OF THE POWER CABLES Cable type Single phase power 110 V~ 3 X 4. 5 mm2 (*) 5 X 2. 5 mm2 (*) 3 X 4. 5 mm2 (*) 4 X 2. 5 mm2 (*) Three phase power 220 V 3N ~ Three phase power 220 V 2N~ Rubber H05 RR-F Polycroropene H05 RN-F (*) keeping in mind the contemporaneousness factor 9 TECHNICAL DATA MODEL WITH 4 NORMAL PLATES VOLTAGE FREQUENCY TOT. RATING 110 V~ 50/60 Hz 5000 W 10 TECHNICAL ASSISTANCE AND SPARE PARTS This appliance, before leaving the factory, has been carefully tested and regulated by expert and specialized personnel in order to guarantee the best performances. [. . . ]