User manual SMEG SE435NE

[. . . ] OUR REGULAR INSTALLERS GUARANTEE A SATISFACTORY JOB. GAS OR ELECTRIC APPLIANCES MUST ALWAYS BE DISCONNECTED BY SUITABLY SKILLED PEOPLE. THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE HOB. [. . . ] The symbols used are described in the table below. FRONT RIGHT-HAND COOKING POWER INCREASE BUTTON TIMER ZONE INCREASE BUTTON REAR RIGHT-HAND COOKING ZONE POWER DECREASE BUTTON TIMER DECREASE BUTTON FRONT LEFT-HAND COOKING ZONE LEVEL I POWER BUTTON REAR LEFT-HAND COOKING ZONE LEVEL II POWER BUTTON CENTRAL COOKING ZONE LEVEL III POWER BUTTON TIMER BUTTON LEVEL TURBO INDUCTION BUTTON COOKING ZONE LOCK-OUT 20 Instructions for the user 5. USE OF THE COOKING HOB To operate the panel of the hobs equipped with touch-controls, press the icons printed on its surface. On first connection to the electrical mains, an operating check will be carried out automatically and all the indicator lights will come on for a few seconds. Under each cooking zone there is a coil called an inductor which is powered by an electronic system and which creates a variable magnetic field. When a pan is positioned within this magnetic field, the high frequency currents are concentrated directly onto the pan producing the heat required for cooking the food. After use, switch off the hotplates using the controls described in paragraph "5. 3. 3 Switching off the hotplate". Never rely on the cookware detector. 5. 1 Operating power settings Below, we provide a table with the maximum power consumptions of the cooking zones that are on. ZONE NUMBER ZONE DIAMETER 160 mm 210 mm 280 mm 280 mm 230 mm 160 mm MAX ABSORBED POWER 2000 W 3100 W 2800 W 3200 W 2800 W 2000 W ABSORBED POWER IN POWER FUNCTION Not available Not available Not available 3600 3100 2200 21 Instructions for the user 5. 2 Cookware Appliances of this type require special pans to be able to work. In fact, the pan must have an iron bottom to generate the magnetic field necessary for it to be heated up. Recipients made of the following are not suitable: 1 glass; 2 ceramics; 3 earthenware; 4 steel, aluminium or copper without a magnetic bottom. To see whether the pan is suitable, bring a magnet close to the bottom: if it is attracted, the pan is suitable for induction cooking. 5. 3. 5 Residual heat Each cooking zone is equipped with a residual heat warning device. After any zone is switched off, a flashing " "may appear on the display. This warns that the cooking zone concerned is still very hot. is flashing: in this case, proceed as described in paragraph "3". Cooking can be restarted while the 23 Instructions for the user 5. 3. 6 Cooking hob lock-out When the hob is on, it can be locked to avoid accidental modifications to the cooking values set. The lock remains on even after the hob has been switched off. It is present only on the models that have the symbol . To activate the lock, with the hob on, press the keys simultaneously until the symbol appears on the display. and and near the cooking zone To deactivate the lock, in the same way, press the simultaneously until the symbol keys near the locked cooking zone disappears from the display. The figure above shows the "grouping" of the cooking zones. When one hotplate is locked, the hotplate in the same group is also locked. Even when the hotplate is locked, it can be switched off pressing its ON/OFF key. In this case, the lock is held until the next time it is switched on: to set a cooking level switching on a locked hotplate, it must first be unlocked following the procedure as described in this section. 5. 3. 7 Power management To optimise the energy consumption, the groups made up of two hotplates (see figure above) are prevented from supplying more than a determined maximum operating power. [. . . ] - Use a larger pan. 26 Instructions for the installer 8. INSTALLATION 8. 1 Technical information Hob type Electrical connections HOB RATING Maximum electrical power See rating plate 220-240V~ 50/60Hz / 380-415V 2N 50/60Hz / 380-415V 3N 50/60Hz I See rating plate 8. 2 The rating plate Make sure that the voltage and capacity of the power line conform to the data shown on the plate located under the casing. Do not remove this plate for any reason. Serial N° Model 8. 3 Electrical connection THE APPLIANCE MUST BE CONNECTED TO EARTH IN COMPLIANCE WITH ELECTRICAL SYSTEM SAFETY REGULATIONS. WHEN LINKING UP TO MAINS BY PLUG AND SOCKET, MAKE SURE THAT BOTH ARE COMPATIBLE AND CONNECT BY MEANS OF A POWER CABLE COMPLYING WITH APPLICABLE REGULATIONS. [. . . ]